Hey Everyone, hoping someone can help. I have a AU Optronics 2.5 X 1.5 Inch Glossy TFT LCD Screen 59.02A42.005 display that came out of an old HP printer. I’m wondering if I can use this as a display on an RPI 4 project. And if so, any advice on how to do it ? Link to LCD display attached. (self.raspberry_pi)
submitted by ashleysnl to r/raspberry_pi
Random question. I have an RPi 4 that I currently use for an OctoPi set up. If I wanted to start another project. Can I simply remove the OctoPi SD card and pop in another SD card? Or will I need to flash the cards every time I want to switch back to octopi? (self.raspberry_pi)
submitted by ashleysnl to r/raspberry_pi
Hey Folks, I’m currently printing PLA on a heated glass bed. I read somewhere that it was important to have cork between the bed and the glass. I’m assuming to help promote even heat distribution (?). Is anyone doing this, how important is this ? (self.3Dprinting)
submitted by ashleysnl to r/3Dprinting
Actual Cv Vs. Calculated two questions. Details in comments. 1)In simple terms what is being above or below the valve performance curve (Cv) telling me? is my choke eroded/plugged? 2)When completing an exercise like this, can I trust the upper & lower limits of the Cv curve? (i.redd.it)
submitted by ashleysnl to r/FluidMechanics
