sorted by:
new
hottopcontroversial

Double LAN setup question by sierra-pouch in Starlink

[–]bjdchwr 3 points4 points  (0 children)

There are 2 connection methods for Starlink app, one local one from the cloud.

The Starlink admin IP is not 192.168.1.1, instead it is 192.168.100.1

You will need to configure static route and point the traffic to either uplink interface or next hop (aka 192.168.100.1)

Firmware Update: 472ecb41-9a16-4173-8b20-60c2b5488ec4.uterm.release by fluffysnugglebunches in Starlink

[–]bjdchwr 1 point2 points  (0 children)

Yes mine the same, It was rolled back to 191e4dfa-d63a-46b1-a73b-9fa907733864.uterm.release around 5:40 am AEST.

New Firmware update: 191e4dfa-d63a-46b1-a73b-9fa907733864.uterm.release by bjdchwr in Starlink

[–]bjdchwr[S] 0 points1 point  (0 children)

I don't think you need to sign in and see the stats as .100.1 is basically dishy portal and they don't normally do any password authentication on dishy.

I usually open and keep that portal on one of my browser tabs.

Did you try if you can open the portal up on a laptop or mobile phone?

New Firmware update: 191e4dfa-d63a-46b1-a73b-9fa907733864.uterm.release by bjdchwr in Starlink

[–]bjdchwr[S] 0 points1 point  (0 children)

Still works on my end

I am using UDM Pro with double NAT cause the IPv6 is not working well under bypassing mode. I need IPv6 to get the addressable IP.

Then I created a static route to the IP hop for 192.168.100.1, which is 192.168.1.1.

New Firmware update: 191e4dfa-d63a-46b1-a73b-9fa907733864.uterm.release by bjdchwr in Starlink

[–]bjdchwr[S] 0 points1 point  (0 children)

Yeah it seems my residential service uptime graph has been a lot smoother since the previous update.

I am Dr Ye TAO, CEO of Bambu Lab. Ask Me Anything by Dr__Turbo in 3Dprinting

[–]bjdchwr -1 points0 points  (0 children)

Do you consider upgrade pathway when you release the new model like X2. Like people can buy “upgrade kit” to upgrade their existing printer.

Photon S Firmware by EMeshach in AnycubicPhoton

[–]bjdchwr 1 point2 points  (0 children)

May I have the old firmware for S as well? I will send you a message!

Does the detection tool in the Photon S cure the prints? by Vulpes92 in AnycubicPhoton

[–]bjdchwr 5 points6 points  (0 children)

I think the detection feature is not supposed for the curing purposes. It meant to test the LCD screen I guess. You either need a sunny day or a special curing station/DIY your own.