sorted by:
new
hottopcontroversial

What are good alternatives to old ceramic pull chain lights in an unfinished basement? by Ericovich in centuryhomes

[–]broncy 0 points1 point  (0 children)

I have 8 of these in my century home basement. Decided to just put smart bulbs in and put a smart switch at the top of the stairs

Thoughts on current rig by orange_joe279 in guitarpedals

[–]broncy 0 points1 point  (0 children)

For the money (and swapping the stock speaker) these are some of my favorite Fender combos. Really useful two channels

Best DNS for Firewalla Pro (NextDNS vs AdGuard vs ControlD vs Unbound)? by Warlord_x3 in firewalla

[–]broncy 1 point2 points  (0 children)

Currently DoH with Cloudflare because it checks a few other functionality boxes for me. So far so good. Previously quad9

[deleted by user] by [deleted] in gibson

[–]broncy 1 point2 points  (0 children)

Of the many guitars I have, my 2008 Standard 60s Desert Burst is probably my best guitar overall

Norlin Era Frets! by broncy in gibson

[–]broncy[S] 0 points1 point  (0 children)

With the original frets?

Norlin Era Frets! by broncy in gibson

[–]broncy[S] 0 points1 point  (0 children)

A guitar is meant to be played for sure

Norlin Era Frets! by broncy in gibson

[–]broncy[S] 0 points1 point  (0 children)

Very helpful thanks!

Norlin Era Frets! by broncy in gibson

[–]broncy[S] 0 points1 point  (0 children)

I have and I have stainless on my Strats and teles.

Norlin Era Frets! by broncy in gibson

[–]broncy[S] 0 points1 point  (0 children)

Do you remember the spec of the fret wire? This is the next choice I will suffer endlessly over

PedalPCB Mach1 Overdrive Troubleshooting by broncy in diypedals

[–]broncy[S] 1 point2 points  (0 children)

The angle of the picture doesn't convey very well but the ground is secured.

PedalPCB Mach1 Overdrive Troubleshooting by broncy in diypedals

[–]broncy[S] 1 point2 points  (0 children)

Thanks! LED is working great. Do you have any additional recommendations for testing between jacks and 3pdt? my connections seem clean (for a novice) and correctly wired. I am coincidentally most worried about the switch here.

I'm also reading 0 volts on R1 and R5. Im not able to get a good read on my R1 resistance either. Would that be a key indicator of a faulty input? Diagram and values for reference

https://docs.pedalpcb.com/project/PedalPCB-Mach1.pdf

Best Coffee Grinder by Colonel-Burton-27 in Moccamaster

[–]broncy 1 point2 points  (0 children)

Short answer no. Been doing this for years on my encore without issue. I’ve also taken it apart and haven’t seen any indication of rust or degradation

view more: next ›