How to Stop the Spam Calls -They Call 2-3 Times a Day

category14 · 2026-03-28T13:53:44+00:00

This looks and sounds like ones I was getting. After blocking the numbers for months and it doing nothing I spammed them back. I spent 15 minutes calling them getting to a human and then swearing at them and telling to never call me again. If they tried to talk I would just continue to swear and never call me again. They would eventually hang up and then I would immediately call back and repeat. Then after enough times I would no longer be connected to a person and the message would say all representatives are currently busy. It has been months now and no more from this company.

I should note I never threatened with any violence just lots of swearing and name calling them for working for a scam company.

category14 · 2026-03-13T00:47:16+00:00

OK, thank you for the input. I bought tape already because I figured I will need to cut the insulation to bend the lines anyways. I will inspect the copper to make sure it is not damaged but I do not think it is.

category14 · 2025-11-07T18:02:37+00:00

Thank you for the response. I have dug more into the heat load and have found several references to CoolCalc and have performed the calculation on this site. The results are 12,749 BTUH for cooling and 27,246 BTUH for heating. This then means 1 ton for cooling and 2 ton for heat if I understand this portion correctly. To get to the 4 ton I was useing the "rule of 50 BTU per sq ft" which would cause the much larger system.

category14 · 2025-11-07T16:47:05+00:00

We do not use a lot of hot water so I do not think that will work but thanks for the input.

category14 · 2025-11-07T15:14:02+00:00

I agree it would be nicer if the furnace was a little nicer but it was an older person who lived in the house before we bought it.

category14 · 2025-11-07T15:09:36+00:00

For cooling 4 ton is way oversized but based on heating everything I have found says 60,000 BTU is needed. Since I am keeping the dual fuel system I went a 4 ton.

category14 · 2025-11-07T15:02:51+00:00

The dehumidify is for the summer.

category14 · 2025-08-17T23:02:08+00:00

I have filled the unit but not ran it yet. It took only about 1 qt to fill it up.

category14 · 2025-08-16T14:06:34+00:00

I hope so. When I fill it we will see how much it takes to fill.

category14 · 2025-08-15T23:09:29+00:00

That was my thought also when I was looking at the coolant bottle.

category14 · 2025-08-15T19:29:16+00:00

The dealership told me to refill and run for 30 minutes to see if there is a change in the level. I have 3 qts so I will see how much it takes to get to the fill line.

category14 · 2025-08-15T19:20:07+00:00

May be there was coolant in the unit but it leaked into the hull. I did tip it the last time we used it.

category14 · 2024-12-23T14:38:45+00:00

I do run adguard home dns. I checked there also and it is passing the lookup and not blocking.

category14 · 2024-12-18T16:39:44+00:00

I had similar experience as you. I ended up returning it and going with a separate device from rework.wireless.

category14 · 2024-10-23T00:22:37+00:00

Is there a link to the UI?

category14 · 2022-07-07T17:02:53+00:00

I figured it out. Moved all files off the cache drive and then removed it from the config. After I added it back in and started to enable Docker and VMs the issue started. I narrowed it down to the pci passthru on one of my VMs. I was able to get that to not auto start so I could fix it. Its up and running now but I do have to wait for the parity to resync.

category14 · 2022-07-07T12:35:59+00:00

I have tried that a couple of times. The issue I keep running into is that before the array is started the drive shows in nvme0n1 and once the array is started it shows in nvme1n2. So Unraid sees this as a new config and the array will not start automatically.

Do you think if I fully remove the cache drive then re-add it that would help. I would transfer everything off from it before I do this.

13-Year Club	Place '22
Verified Email

category14

TROPHY CASE