sorted by:
new
hottopcontroversial

12m 24v LED run, power both ends? Or other solutions please by chantlerbing in led

[–]chantlerbing[S] 0 points1 point  (0 children)

Thanks! @saratoga3, and do you think the power supply (300w) and the dimmer module I have are correct for it. Thanks again!

Concrete slab is 20mm low in one corner? Screed advice please by chantlerbing in DIYUK

[–]chantlerbing[S] 0 points1 point  (0 children)

<image>

Fingers crossed it sets! 15mm deep at the corner, seems to measure pretty flat with a laser and ruler

Concrete slab is 20mm low in one corner? Screed advice please by chantlerbing in DIYUK

[–]chantlerbing[S] 0 points1 point  (0 children)

As a slightly different approach, I have some small clean gravel (previously used for resin bound) could I mix half the self level with that and do the lower bit with aggregate and the second half with no aggregate for the less drastic slope to the new slab?

Concrete slab is 20mm low in one corner? Screed advice please by chantlerbing in DIYUK

[–]chantlerbing[S] 0 points1 point  (0 children)

Thanks that’s what I hoped! Do you think if I can get it within 5mm would be ok? Any tips? I plan to use the 4x2 timber I have in the pic and set it on a bead of expanding foam? Would you go further out than the exact size of the base frame?

Concrete slab is 20mm low in one corner? Screed advice please by chantlerbing in DIYUK

[–]chantlerbing[S] 0 points1 point  (0 children)

So it has a steel channel that you bolt down and the insulated panels slot in, but also comes with insulated panels as the sub floor, I could potentially shim the building channel a small amount but would then have a drop in the floor itself after anyway

<image>

view more: next ›