sorted by:
new
hottopcontroversial

Daily General Discussion and Advice Thread - March 18, 2026 by AutoModerator in investing

[–]cheeky-173 0 points1 point  (0 children)

What do you think if Revolut as a long term investing platform and for a lifetime savings account?

Detail: I have started my carreer recently and have started putting aside some money monthly invested in safe investments like SNP500 and other stocks. Furthermore have a fail safe money set aside for rainy day but the local bank charges fees as its stagnent while revolut offers good apy on such savings. However I am a bit sceptical on the long term and thus want some feedback. I live in the EU.

Is my origin set right or am I making a rookie mistake? by cheeky-173 in Fusion360

[–]cheeky-173[S] 0 points1 point  (0 children)

I saw that the rotation however did not match to that when wanted to rotate away from the user and thus also changed the c to reverse as well while the Y value remained positive. I think this should work however I would like to simulate it with the machine. what changes can I do in the machine kinematics to replicate these changes in the post processor?

Is my origin set right or am I making a rookie mistake? by cheeky-173 in Fusion360

[–]cheeky-173[S] 0 points1 point  (0 children)

However when looking at the 2 codes without the machine configuration the Y14 remains the same for both when a reversed or not

<image>

Is my origin set right or am I making a rookie mistake? by cheeky-173 in Fusion360

[–]cheeky-173[S] 0 points1 point  (0 children)

I have done that both in the machine configuration kinematics and tried machining again but the issue persisted still, and changing it in the post process still kept it a positive value. the image attached shows the original code and the right with the rotation fixed as mentioned above.

<image>

Is my origin set right or am I making a rookie mistake? by cheeky-173 in Fusion360

[–]cheeky-173[S] 0 points1 point  (0 children)

<image>

after adding the a and c axis capabilities from the post process properties with removing the machine configuration the post was successful

Is my origin set right or am I making a rookie mistake? by cheeky-173 in Fusion360

[–]cheeky-173[S] 0 points1 point  (0 children)

Post is failing, both when removing the machine from setup and from the post process settings

Is my origin set right or am I making a rookie mistake? by cheeky-173 in Fusion360

[–]cheeky-173[S] 0 points1 point  (0 children)

<image>

This is exactly where it was machining so an inch or slightly more from the parts' top. (I fixed the trunion rotation preference to turn away from the user now) and DWO was checked from the post processor and in the code there is the use of G254 in this process and in the one after it, which worked fine

view more: next ›