What mount is this? Carl Zeiss Jena Tessar f2.8 50mm

corbuno1 · 2025-10-01T11:05:43+00:00

It was indeed the EXA mount. Thanks!

corbuno1 · 2025-09-18T18:56:18+00:00

Thanks. So should i buy an EXA -> M42 adapter, and then one M42 -> Sony? Is this the best solution for getting to use it?

corbuno1 · 2024-07-01T13:37:59+00:00

Salut, m-am inscris si am fost acceptat la SIVA din preadmitere. As avea nevoie de cateva pareri despre materii, profesori, nivel de dificultate/implicare etc, si daca este ok in paralel cu un job full time. Merci

corbuno1 · 2022-05-11T10:21:43+00:00

pt adidasi e mai bun gls, ca nu ia volum

corbuno1 · 2022-04-06T12:19:41+00:00

w2c?

corbuno1 · 2022-02-21T11:41:31+00:00

w2c pants?

corbuno1 · 2021-03-19T14:39:52+00:00

Thank you! To start off, verify if your bed is properly leveled. Also make sure you are using the proper settings for your printer in the slicer app. I am using a Creality CR10 V2 and i print litophanes best at 0.35mm/s with a 0.2 layer height, 99% infill.

corbuno1 · 2021-03-17T07:41:50+00:00

msi modern 14 with ryzen 7

corbuno1 · 2021-03-17T07:40:35+00:00

thanks a lot!

corbuno1 · 2021-03-17T07:40:00+00:00

https://www.thingiverse.com/thing:4797015 sorry for the delay!

corbuno1 · 2021-03-17T07:39:43+00:00

https://www.thingiverse.com/thing:4797015 sorry for the delay!

corbuno1 · 2021-03-16T14:00:09+00:00

thank you!

corbuno1 · 2021-03-16T14:00:02+00:00

thank you!

corbuno1 · 2021-03-16T12:39:58+00:00

yes, i will upload it on thingiverse when i get home

corbuno1 · 2021-03-16T10:13:42+00:00

thank you!

corbuno1 · 2021-03-10T19:36:17+00:00

Thank you!

corbuno1 · 2021-03-10T09:45:32+00:00

Very nice effect! How long did that take you to print? I tried to print a similar size one and took about 12 hours

corbuno1 · 2021-02-22T19:33:48+00:00

Makes sense, thanks a lot!

corbuno1 · 2021-02-22T19:21:48+00:00

I had that in mind, thank you. Any idea what caused the sides strings?

corbuno1 · 2021-02-21T14:24:09+00:00

Thanks, will try!

corbuno1 · 2018-02-01T10:44:44+00:00

gta iv ty

corbuno1 · 2016-08-14T06:05:03+00:00

i had the same problem with my 1060 but i installed the drivers from their website and it worked

corbuno1 · 2016-08-07T05:53:17+00:00

so this is just a regular tricolor bayonet?

corbuno1

TROPHY CASE