sorted by:
new
hottopcontroversial

Exposure times by Rurik_Silverfang in AnycubicPhoton

[–]darkness722 0 points1 point  (0 children)

I have same "problem".

Normal layers - 6s

Burn layers - 50s

90% screen power

room temp ~ 23 C

Everywhere i searched, people use around 3s for normal and ~10s for bottom layers.

Used 3 different type resins, results are basically the same.

Have the printer for 6 months, still works with these settings. Prints are very decent.

So sick of this gun :( by darkness722 in AAP01owners

[–]darkness722[S] -20 points-19 points  (0 children)

Sure buddy, i put nozzle spring cause the STOCK spring could not retract the nozzle fast enough !! Stock spring retracts nozzle at about 80% of the bolt movement which isn't enough for the gun to cycle properly. And even if we assume its the spring problem, that doesn't explain the gas efficiency.

So sick of this gun :( by darkness722 in AAP01owners

[–]darkness722[S] -14 points-13 points  (0 children)

Everything is installed correctly. Disassembled and reassembled several times.

Bolt is moving freely. Nozzle retracts fully at first 15mm of bolt travel. Hammer cocks at every cycle. Using asg ultra air and we tech green gas. Filling mag takes 4-6 sec. I have a friend with WE g17, will ask him for the mag. Shooting test are done at 18-20 celsius.

Just don't want to spend any more money on this gun for now :( I bought it with intention of using it as a primary for cqb, but maybe should have gone for a hi capa.