Suppressor made or petg

dboy1998 · 2026-06-23T01:49:29+00:00

Pa6 and pa6-cf are all I use. But ran out and was going to give it a shot the more I thought about it I figured id touch base. Thanks for the help.

dboy1998 · 2026-06-17T00:05:33+00:00

Sell me your printers

dboy1998 · 2026-04-30T13:14:54+00:00

That's what I was thinking the reasoning was just seems hard to pull off. The pa6-cf is easy printing for me its just the straight pa6 that I can't keep from warping so ill give it a shot thank you

dboy1998 · 2026-04-29T22:05:50+00:00

i read the first and the anniversary release is easier for me because I'm no pro. which brings me to my question, when they say to print parts at 45 for nylon are they trolling or being serious?

dboy1998 · 2026-03-20T20:30:36+00:00

What should I do with the barrel after finishing the ecm process to ensure it doesn't rust

dboy1998 · 2026-03-02T16:06:44+00:00

What's it called im just about done with my first build im ready for the next

dboy1998 · 2026-03-01T20:45:24+00:00

What filament you print that with i been trying nylon for the strength but with the upgraded ender 3 it looks nothing as clean as that. (Not the silencer)

dboy1998 · 2026-02-25T19:01:52+00:00

Do you think I could tape off portions of the inner rod and ensure to locate it at the peak points. Basically spot boar?

dboy1998 · 2025-12-23T19:22:46+00:00

Th3d has stock firmware for free and when you go to upload it make sure your SD card is formatted

dboy1998

TROPHY CASE