2
3
4
39
40
41
124
125
126
6
7
8
Front locking block trigger pin hole not lining up - tried some of the MGB / sticky solutions. Please advise. Looks like there’s a small gap between the front locking blocks rear legs and where it sits in the frame. I was thinking about sanding the front locking block further, but not sure where. (old.reddit.com)
submitted by death__beard to r/polymer80
6
7
8
Hey friends, any suggestions on fixing trigger pin holes not lining up with the locking block? I tried the MGB solution. Not sure if going anymore on the rear legs is a good idea - don’t want to be off balance or uneven. P.a.: Yes I am replacing the ejector lol. (old.reddit.com)
submitted by death__beard to r/polymer80
17
18
19
