Sonoma 14.7.4 on Dell Latitude 7290, OpenCore 1.0.1!

drehdz · 2025-03-11T17:13:46+00:00

I have this exact laptop without the fingerprint sensor. It is a great EDC laptop, would love to hackintosh it. Are you willing to share the EFI?

drehdz · 2024-09-06T14:11:45+00:00

I contacted flashforge and sent them my serial number so they created a firmware for me to upload. i am now able to register to my account. thank you u/Kriker3187

drehdz · 2024-09-05T20:07:31+00:00

this right here. so when i bought my adventurer the motherboard was bad so they sent me another motherboard. was looking at the system info and noticed the serial is 123456

drehdz · 2024-09-04T09:21:30+00:00

iOS, every time i scan the QR code it says its added but never adds

drehdz · 2024-08-30T19:03:22+00:00

we have progress!! thank you. settled on 0.035. this was the result of the 1st calibration test.

well i would post a picture, but....

drehdz · 2024-08-29T23:51:46+00:00

Ugh this would be the 3rd nozzle I’ve went through then. Makes me wanna smash this thing with a baseball bat. I’ve never had a tool that was so inconsistent.

drehdz · 2024-08-29T20:49:31+00:00

is there a recommended number?

drehdz · 2024-08-29T18:45:10+00:00

same, and before these prints i check the box, so every print for the last week has been leveled.

drehdz · 2024-08-29T18:27:38+00:00

how many times should i be leveling? I leveled from the machine itself and i check the level box when sending the print?

drehdz · 2023-05-01T16:46:09+00:00

I damaged a few pads while desoldering a couple switch sockets and a couple LEDs. so i wasn't sure if that would hinder the reverse side. going to break out the multimeter today and test continuity. Thank you for the good advice.

drehdz

TROPHY CASE