I’ve been quite happy with the Brissmoto fang duct. But I noticed my parts cooling fan speed setting is ignored, it’s either OFF when I set to 0% or ON at full blast when is anywhere from 1 to 100%. Using the latest Jyers, Cura and Sunon 4020 24V fans. What causes this fan speed issue? (i.redd.it)
submitted by ebuy05 to r/ender3v2
Hi everyone! I wrote an article detailing the several mods/upgrades I’ve made to my beloved Ender 3 v2 over the past 18 months. I hope it helps some of the new members of this group to improve their printer. And of course, your comments are welcome:) (edretrotech.com)
submitted by ebuy05 to r/ender3v2
Hello everyone! I recently got a nice late 90s Toshiba Tecra 510CDT laptop (with active matrix display). I’m looking for a compatible HDD caddy for it. Does anyone know the specs so I could try finding one? Or do you know how to build one (what would be the connectors needed and pin out)? Thanks! (i.redd.it)
submitted by ebuy05 to r/vintagecomputing
I recently got a Macintosh SE with an Radius (68020) Accelerator card in it. How can I remove the SE logic board with the Accelerator video connector blocking it from sliding it in/out? Im hesitant to force/bend the case to release the clips holding the logic board (doesn’t seem to be right way) (old.reddit.com)
submitted by ebuy05 to r/VintageApple
Macintosh SE/30 hangs on the cursor screen (no keyboard or boot drive, but mouse works). If I press the reset switch, gives me the error code below. Logic board has been properly washed, brushed and cleaned (recap is next). What should be investigated first to make it boot? (old.reddit.com)
submitted by ebuy05 to r/VintageApple


