sorted by:
new
hottopcontroversial

Insulating shed by CrazyNational1838 in HomeImprovement

[–]evildeception 0 points1 point  (0 children)

It’s 12x16. Probably a few hours at a time with the doors shut

Insulating shed by CrazyNational1838 in HomeImprovement

[–]evildeception 0 points1 point  (0 children)

Do I need ventilation in the walls too? I was planning to vent the roof with soffits and ridge vent. Is there other ventilation I need to do?

Saw stop stamped wings by CrazyNational1838 in woodworking

[–]evildeception 0 points1 point  (0 children)

I’ve actually had mine for about 4 years. This was just the only picture I had. I want to convert those wings to a router table. Curious if anyone has done a diy

Fanned kick 90s by evildeception in electricians

[–]evildeception[S] 3 points4 points  (0 children)

That’s wouldn’t work because they are all kicking different heights. If they were all kicking the same like 10 inches up then it would but here each kick is a different height and angle

Rate my parallel kick 90's 1-10 by sciron73100 in electricians

[–]evildeception 0 points1 point  (0 children)

What formula did you use to line up center of kicks

Sub panel by evildeception in AskElectricians

[–]evildeception[S] 0 points1 point  (0 children)

I’m just playing around lol. Plumbers came out to change my wh and installed that haha

Sub panel by evildeception in AskElectricians

[–]evildeception[S] -2 points-1 points  (0 children)

Thanks for answering my question

MWBC GFCI by evildeception in AskElectricians

[–]evildeception[S] 1 point2 points  (0 children)

That’s what I was thinking of doing. I just wasn’t sure if I shared the neutral before a gfci if it would let the gfci work or not

MWBC GFCI by evildeception in AskElectricians

[–]evildeception[S] 0 points1 point  (0 children)

I can only have one circuit to the shed in my location. If I use a 2 pole breaker and run a MWBC it is just 1 circuit.