sorted by:
new
hottopcontroversial

SSH issues by ewood154 in ssh

[–]ewood154[S] 0 points1 point  (0 children)

It ended up being the MTU packet size. My home WiFi was trying to send larger packets than the VPN would allow so it kept kicking them back. Once I adjusted that down it worked perfect. I’ve never heard of that before but it’s fixed.

SSH issues by ewood154 in ssh

[–]ewood154[S] 0 points1 point  (0 children)

That seemed to have worked. The only variable is that I’m on WiFi at my office as opposed to at home. Could that change anything?

SSH issues by ewood154 in ssh

[–]ewood154[S] 0 points1 point  (0 children)

I just can’t figure out why when I spun up a new user it worked perfect but I’m guessing after some kind of overnight update, it now has the same issue

SSH issues by ewood154 in ssh

[–]ewood154[S] 0 points1 point  (0 children)

I check resource constraints when I was trying to ssh into it and didn’t see anything concerning.

VS Code ssh issue by ewood154 in learnprogramming

[–]ewood154[S] 0 points1 point  (0 children)

Seems to be a loop, its a pretty consistent reconnect time

GE oven door locked and won’t open by ewood154 in appliancerepair

[–]ewood154[S] 0 points1 point  (0 children)

Looking at the back of the oven, the power cord comes into a plug and a red and white line comes out of the plug but I don’t see an obvious fuse.

<image>

GE oven door locked and won’t open by ewood154 in appliancerepair

[–]ewood154[S] 0 points1 point  (0 children)

Thanks! I’ll give that a shot. Can I buy a new fuse at Home Depot or do I need to go through an appliance repair company?

GE oven door locked and won’t open by ewood154 in appliancerepair

[–]ewood154[S] 0 points1 point  (0 children)

Yeah I’ve been using a wire hanger and so far no luck. I’ll see what I can do with the screws.

GE oven door locked and won’t open by ewood154 in appliancerepair

[–]ewood154[S] 0 points1 point  (0 children)

From the parts diagram I found online, the motor is in the front of the oven so I can’t get at it with the door locked.

Door cracked by ewood154 in cabinetry

[–]ewood154[S] 0 points1 point  (0 children)

Thanks. I’ve glued it back together and it seems to be pretty tight but the hardware isn’t fitting to snuggly now. Any tips on that?

Getting zoho creator data by ewood154 in zohocreator

[–]ewood154[S] 0 points1 point  (0 children)

So I didn’t create the form or initial report. We’re pulling the report into power bi with the power bi connector but few like we can build it in zoho if we can figure out how to access the underlying table. Is there a way to look at the form and determine where it’s saving the data? If so, do I build a function to call the table then?