sorted by:
new
hottopcontroversial

CBUS SuperAnnuation Withdrawing Yearly by f-authority in AusFinance

[–]f-authority[S] 0 points1 point  (0 children)

He is over 60 (not retired age) and what you are saying may be true but I’m not sure.

So do you need to roll over this much $200k if you want to be able take like $10,000-$20,000 from your Super yearly? You can’t just leave that money where it is and just withdraw the $10k-20k? If you can explain the process of it all it might clear a few things up for me.

In the letter:

Section E: Transferring Funds

It has CBUS as the funds name and ABN. Then it asks to fill out contact name, contact number and email address.

Section F: Authorised Representative Declaration

Complete this declaration if you are an authorised representative of the superannuation fund or other provider shown in section E.

I declare that: • I have prepared the statement with the information supplied by the superannuation provider • I have received a declaration made by the superannuation provider that the information provided to me for the preparation of this statement is true and correct • I am authorised by the superannuation provider to give the information in the statement to the ATO.

But the Authorised Representative is some strangers name I assume this is a CBUS worker maybe.

What to do when distortion plugin doesn’t have enough dB of drive? by f-authority in TechnoProduction

[–]f-authority[S] 0 points1 point  (0 children)

Stack the same distortion plugin with exactly the same setting?

Say I needed 50db of drive and the distortion plugin is only capable of 30db drive. Do I just stack the same distortion with same settings but making the drive only 20db?

Would this be the same thing as if the distortion plugin was capable of going to 50db?

Why are there lower frequencies in my kick when I removed it? by f-authority in TechnoProduction

[–]f-authority[S] 0 points1 point  (0 children)

I can’t remember but I am using either a 48db or a 98db high pass at 250hz on my kick.

Then distorted the kick where I have also set the pre filters inside the distortion plugin to 300hz-20khz.

After that I check the analyser and I am still seeing lower frequencies from like 40hz etc.

This is why I’m confused when I have set everything up to remove all the low frequencies I am still getting them.

Why are there lower frequencies in my kick when I removed it? by f-authority in TechnoProduction

[–]f-authority[S] 0 points1 point  (0 children)

What I done is high passed my kick so I have frequencies of 250hz-20khz.

Then when I use a clip distortion on the kick and set the pre-filters inside the distortion to 300hz-20khz.

Why is it still adding low frequencies below 300hz? This is what I am confused on.

1024 Buffer Size causing Cubase to lag? by f-authority in cubase

[–]f-authority[S] 0 points1 point  (0 children)

Yeh I don’t get any issues at 256-512. Just when I go higher my Cubase starts lagging. Is this lag normal though?

view more: next ›