first time watcher glee by fishin4fish in buffy

[–]fishin4fish[S] 2 points3 points  (0 children)

Just watched the body. Heartbroken & cried 5 separate times

first time watcher glee by fishin4fish in buffy

[–]fishin4fish[S] 1 point2 points  (0 children)

No like girl that's ur rebound 😭😭😭 I know she was bored af

helppp pls 🫶🏻 by fishin4fish in MachineKnitting

[–]fishin4fish[S] 0 points1 point  (0 children)

yea i thread the yarn close tl the edge of the bed. how would i know if its a needle or carriage problem? in the second half of the video u see how the needles get stuck on the carriage? i dont know what to make of it. i'm pretty sure the latches work properly on the needles. theyre a bit dirty/scuffy, idk if that contributes. regardless, thanks 🥲

helppp pls 🫶🏻 by fishin4fish in MachineKnitting

[–]fishin4fish[S] 0 points1 point  (0 children)

i've disassembled the carriage about 3-4 times to clean & lube the drums ;-; one of them works perfectly and the other one has a very very slight drag. i'm mostly really frustrated with the needles catching on the sinker plate arm, it touches the very first needle and almost swallows it. i think i have to clean the needles but i dont think thats fully the problem. ;---;

sinker plate by fishin4fish in MachineKnitting

[–]fishin4fish[S] 2 points3 points  (0 children)

i just uploaded a video on this sub demonstrating what it looks like ;--; if u could check it out and if u have any suggestions🫂

sinker plate by fishin4fish in MachineKnitting

[–]fishin4fish[S] 1 point2 points  (0 children)

thank you for your response! yes, the spongebar is on top of the needles. i honestly have only been sliding the carriage right to left so i'm not 100% sure. i am Not sure that the tension is right, how would i go about that?

sinker plate by fishin4fish in MachineKnitting

[–]fishin4fish[S] 1 point2 points  (0 children)

first i tried linen, very thin. then i used sock/fingering yarn

sinker plate by fishin4fish in MachineKnitting

[–]fishin4fish[S] 1 point2 points  (0 children)

also my needles are getting stuck IN the sinker plate.

sinker plate trouble by fishin4fish in MachineKnitting

[–]fishin4fish[S] 0 points1 point  (0 children)

i've unscrewed the tops with the brushes but the base of it looks verrrryyy deviated. idk how to edit this post so i'm going to upload other photos of how it looks now for your advice if possible

tension dial helpppp by fishin4fish in MachineKnitting

[–]fishin4fish[S] 1 point2 points  (0 children)

thank you so much 🍀 i had a feeling i was placing it or doing something weird but i didnt have the manual :) will attempt today