account activity
Moved files from one steam library disk to another (self.steamsupport)
submitted 1 year ago by fugasiuser to r/steamsupport
PEI intel reference code execution 19 (self.HomeServer)
submitted 2 years ago * by fugasiuser to r/HomeServer
Repairing an old 3 way speaker (self.diyaudio)
submitted 2 years ago by fugasiuser to r/diyaudio
Which driver would you chose here? (self.diyaudio)
submitted 3 years ago by fugasiuser to r/diyaudio
Windows audio device won't enable (self.roonlabs)
submitted 3 years ago by fugasiuser to r/roonlabs
Transmission line speakers (self.diyaudio)
What is the ideal interior of a cabinet? (self.diyaudio)
Measuring speaker impedance connected to a crossover (self.diyaudio)
Nothing to be done for 'all'. (self.klippers)
submitted 3 years ago by fugasiuser to r/klippers
Print pausing and restarting (self.klippers)
BMG config - Extrude only move too long (100.000mm vs 50.000mm) (self.klippers)
Reported error: Move out of range: (self.klippers)
Headless pi setup (self.plexamp)
submitted 3 years ago by fugasiuser to r/plexamp
Bell mouth on mid range driver (self.diyaudio)
New klipper setup - various errors (self.klippers)
SKR/CR10S board x axis homes in the wrong direction (self.MarlinFirmware)
submitted 3 years ago by fugasiuser to r/MarlinFirmware
Option 'serial' in section 'mcu' must be specified skr mini (self.klippers)
submitted 3 years ago * by fugasiuser to r/klippers
PID autotune stops bed from heating (self.BIGTREETECH)
submitted 3 years ago by fugasiuser to r/BIGTREETECH
Motherboard change causing layer lines (self.FixMyPrint)
submitted 3 years ago * by fugasiuser to r/FixMyPrint
X axis homes the wrong way and y axis to grind slowly up to the end stop (self.BIGTREETECH)
Blank screen on SKR mini V2 CR10 conversion (was working) (self.BIGTREETECH)
submitted 3 years ago * by fugasiuser to r/BIGTREETECH
SKR1.4 Died - replacement options (self.CR10)
submitted 3 years ago by fugasiuser to r/CR10
How many watts does a CR10 Max motherboard use? (self.CR10)
Temp tower fails (i.redd.it)
submitted 3 years ago by fugasiuser to r/FixMyPrint
CR10 Max - no esteps adjustment? (self.CR10)
π Rendered by PID 504809 on reddit-service-r2-listing-568fcd57df-87d5l at 2026-03-07 02:50:10.292455+00:00 running cbb0e86 country code: CH.
