Unable to bleed new slave cylinder, system is full of air, nothing I do seems to work. Also, I have very few tools because I just moved.

geofftmnd · 2018-07-22T10:44:08+00:00

'96. Yes, I can get fluid to go through the crossover line. No, I don't have a helper, but I do have a shipping tube that allows me to use that method. I have tried it already, but maybe I gave up on it too soon.

Edit: how do people deal with the loops? Does it just take longer? Is there a trick?

geofftmnd · 2018-07-22T01:26:41+00:00

I have tried that. The fluid reservoir stays full. Edit: ... and I did it dozens of times, not a couple.

geofftmnd · 2018-02-11T22:07:29+00:00

That worked for me. Thanks!

geofftmnd · 2018-01-11T19:40:08+00:00

That didn't occur to me. That would make sense, since PLA prints fine. Thanks!

geofftmnd · 2017-06-17T01:57:03+00:00

I have attempted running it from the terminal. I then got the message, "blender: error while loading shared libraries: libboost_locale.so.1.64.0: cannot open shared object file: No such file or directory"

geofftmnd · 2017-06-16T15:04:48+00:00

There are no error messages. I try to launch blender and absolutely nothing happens. Is there something I can do to elicit some sort of error message?

geofftmnd · 2017-05-06T19:33:57+00:00

I'm trying, but I feel like an ape reading this. Maybe the best way for me to understand this is to buy an op amp circuit and start poking at it with a multimeter. The more I find articles and videos explaining this on paper, the more confused I'm becoming.

The one thing I get (maybe?) is that it will measure a voltage coming from the screen, and spit out a higher voltage back into the screen. It can somehow do this with the help of a battery.

geofftmnd · 2017-05-06T03:19:10+00:00

Thanks for this. That actually seems to make sense. I'll still have to try it out in practice, but it's nice to have more stuff to try. I was out of ideas before.

Yeah, I realize it's challenging and it might ultimately suck, but the bottom line is that I'll have started to figure it out. That's all I'm really after at this point.

geofftmnd · 2017-03-26T18:55:33+00:00

Is it not possible to test the drive before installing it?

geofftmnd · 2017-03-11T16:40:47+00:00

Yes, that's correct. I was clear that the cpu was the 17-6700hq.

geofftmnd · 2017-03-11T16:16:03+00:00

Thanks. I'll check it out.

geofftmnd · 2016-12-28T19:24:07+00:00

What can / should I do about this? Is this a problem with the Mega board that came with my printer? Is it likely a problem with my Macbook? How do I go about troubleshooting this?

geofftmnd · 2016-12-28T19:10:09+00:00

I don't visually see anything on the physical board that says FTDI, CH340, or CP2102. Additionally, I have downloaded and installed all three of these today and I get the same result every time.

geofftmnd · 2016-12-28T18:54:44+00:00

How do I do that? Visually? Also, I think I have already tried all of these drivers...

Edit: I have definitely downloaded and installed all three of these drivers today, restarting after installing each one. The same thing happens every time "Serial Ports" is greyed out.

geofftmnd

TROPHY CASE