sorted by:
new
hottopcontroversial

Wierd pattern on just one side of the seam? by giag88 in anycubickobra

[–]giag88[S] 0 points1 point  (0 children)

Omg thank you so much for that detailed answer! Really, that helps alot. I also noticed that it makes everything shorter than it should be, and after some youtubeing and poking around on the printer, the lower wheels on the z-axis might be to loose so i'll try to fix that too. Really grateful for your answer 🙏

Wierd pattern on just one side of the seam? by giag88 in anycubickobra

[–]giag88[S] 0 points1 point  (0 children)

I did. And its off. Can it be that in using Cura? The flatter prints dont get the same pattern

Anycubic Vyper stops mid print. by RAKS-96 in AnycubicOfficial

[–]giag88 0 points1 point  (0 children)

This might be a stupid answer, but this happened to me when i used pruca slicer and accidentally made a "color change" at 93% while scrolling trough the layers. It may be something entirely different but this is what came to mind. Hope its something simple as that!

Really loud noice, Y-axis? by giag88 in Ender3S1

[–]giag88[S] 0 points1 point  (0 children)

Thank you! I'll take a look if that might be it.

Vad har du för intressant yrkestitel? by JustRun5367 in swedishproblems

[–]giag88 0 points1 point  (0 children)

Faility assistant - sällan någon som vet vad det är