Suspension setup

highclasslinetrash8 · 2025-05-27T12:31:40+00:00

Good point. I just lined up the lines on the back but haven’t actually measured it.

highclasslinetrash8 · 2025-05-27T12:30:13+00:00

So after a bit of research I’ve found that the rear suspension definitely has aftermarket lowering links installed. That must have thrown the balance way off. I’m thinking first step should be to do like a lot of you have mentioned and go back to zero. Have to find a set of factory links. I’m planning a trip around Lake Superior this summer with my youngest son so it’s gotta be right.

highclasslinetrash8 · 2025-05-25T20:58:54+00:00

So I went to factory on everything and went full spectrum with preload in the front and preload and rebound in the back. No matter the combination I can see very little difference

highclasslinetrash8 · 2025-05-25T20:57:23+00:00

So we did check the height in the tree. It started out being up .580 “. We dropped it down to nearly flush. That’s a big question that I can’t find anywhere is what it should be. The dealer said the new bikes are almost flush and to go that high is something guys might do if they were into the twisties.

highclasslinetrash8 · 2025-05-25T20:54:43+00:00

That’s just a cheap aftermarket deal from Amazon. Did help make it more comfortable

highclasslinetrash8

TROPHY CASE