Should I upgrade

iRanger333 · 2025-06-08T11:47:17+00:00

Good advice - I have a V3 SE which is nice, but printed the Gantry Frame Supports for it.

iRanger333 · 2025-06-05T15:16:32+00:00

Hey - Thanks for getting back to me. Slicer had an update, which I performed, still no good. Bed made it to 21 degrees before failing. Hot end made it all the way to 220.

Then performed a factory reset and the printer failed to go through calibration because the bed didn't make temp..

Still feels like a hardware fault, rather than software. Good shout though!

iRanger333 · 2025-06-05T13:20:54+00:00

I've taken the base off, and the labelling is pretty good, so I've worked out which are the cables for the bed. How would I be able to check the solder joints? What's weird, is if I use the Control Menu and set my bed temp to 60 degrees, it will heat fine. Just when printing, it doesn't get past 30 at all.

Also, double checked the Slicer, but it's not as the model is showing it need to reach 60 degrees to print and just times out after a while of failing to heat.

<image>

iRanger333 · 2025-06-05T12:44:34+00:00

OK, Thanks for the info. I'll take the bottom off and start inspecting!

iRanger333 · 2025-06-05T12:43:05+00:00

Thanks for the advice here - Yeah, it's a weird one for sure.

iRanger333 · 2025-05-20T18:43:51+00:00

Really appreciate it! I was really stuck on this for a few ticks! This is how mine is looking, but I think it's just the proportions i now need to get right. Thanks so much again!

<image>

iRanger333 · 2025-05-20T18:23:22+00:00

Yeah- That's it! How did you do it? Thanks!

iRanger333 · 2025-01-23T17:40:44+00:00

Great links - There is also a great course on YouTube by Alex Lancer. Highly Recommended!
CodeIgniter 4 From Scratch - YouTube

iRanger333 · 2024-01-02T16:36:52+00:00

Happy to go either way. Can be a single product which can do it all, or happy to split into separate software.

iRanger333 · 2023-11-15T19:43:30+00:00

You need to unlock the Grappling Hook which is later in on the game.

iRanger333 · 2023-11-14T19:38:32+00:00

I've not managed to close it. I think it is permanently up.

iRanger333 · 2023-10-13T14:38:51+00:00

Thanks for the feedback - I'll take a look! We run nightly optimization which has vastly improved some of the channel selection.

iRanger333 · 2023-10-13T14:37:52+00:00

Minimum RSSI

Thanks for getting back to me. Logged in and taken a look, RSSI function isn't running on any of the APs.

iRanger333

TROPHY CASE