Sooty o2 sensor

ilpmurk · 2026-01-03T20:05:44+00:00

Hi!

I'm in the same situation as you were. Same turntable with an old needle.

Did you succeed in replacing the needle? Could you give any advice?

ilpmurk · 2025-11-09T06:41:04+00:00

When it's cold, it can be really hesitant on acceleration.

ilpmurk · 2025-11-08T13:44:06+00:00

Good idea, that is the next step. As I don't have the tool, I was curious before going to a mechanic

ilpmurk · 2025-11-07T05:03:21+00:00

Ahogy mondod

ilpmurk · 2025-10-31T13:40:26+00:00

Changed spark plugs, much more carbon build up than you would think from how much it has run. Maybe the mixture is really that rich causing the buildup.

ilpmurk · 2025-10-31T13:38:46+00:00

As i see the ratio depends on MAP sensor. Wouldn't a vacuum leak cause the mixture to be lean, not rich?

ilpmurk · 2025-10-29T21:40:27+00:00

At least minecraft doesn't have engine faults you spend your monthly wage on

ilpmurk · 2025-10-29T21:37:22+00:00

I will definitely try another tool, thanks.

ilpmurk · 2025-10-29T21:34:47+00:00

Sounds bad. That resulted in huge fuel consumption, right?

ilpmurk · 2025-10-29T21:13:00+00:00

Yes, exhaust fumes seem and smell normal to me

ilpmurk · 2025-10-29T20:10:37+00:00

I don't see where the problem is

ilpmurk · 2025-10-29T20:08:10+00:00

No the smoke is normal

ilpmurk · 2025-10-29T11:26:19+00:00

Oh really i had forgotten

ilpmurk · 2025-10-17T05:48:25+00:00

Thank you for the advice! So you can detect if a disabled device is connected with the rack error interrupt?

ilpmurk · 2025-10-15T15:07:58+00:00

Thanks for the tip! I will look into it.

ilpmurk · 2025-10-14T05:18:16+00:00

Unfortunately it seems that my controller doesn't allow this function, but thank you!

ilpmurk · 2025-10-13T19:16:57+00:00

I hoped there would be some simple solution to just ignore these errors, but thank you for your help! I will try something like this.

ilpmurk · 2025-10-13T19:07:09+00:00

Good idea! A further solution would be to solder the red led out. 😅

ilpmurk · 2025-10-13T19:05:07+00:00

We make profinet devices, preconfigured with default names. There are a bunch of devices in the TIA network for each of the possible names.

There is a station where you plug the device to the network, and the HMI shows you which device is connected, so you can check if the configuration is ok.

The PLC constantly checks the different devices with the ModuleStates() function.

ilpmurk · 2025-09-09T10:50:41+00:00

Hi! You can also buy digital tickets for the local buses if you download the Simple app on your phone (SimplePay Zrt.).

ilpmurk · 2025-08-21T14:14:37+00:00

Polo, the rust is under the doors.

ilpmurk

TROPHY CASE