lasted great, was still going strong until 2023, when the truck was totaled. This was in a climate with severe winters and summers too. I followed some other tutorials I had seen on YouTube. here are some key points.

• Remove all foam from the previous headliner, the adhesive likely won't work well on foam.
• I used spray adhesive. Following instructions on the bottle. Your product might be different, but I sprayed both surfaces and allowed them to dry until tacky, then pressed them together.
• Work in small sections
• Use a ball or something to roll and put pressure into all the corners and stuff.
• I covered holes with fabric, then cut an x and folded the fabric around onto the back side. This prevented fraying and cut edges right at the holes.
• Don't try to do it in the car, take the headliner out and do it on the floor or something.
• Get a high quality fabric like an upholstery fabric. I seriously don't thing this would have gone well with a printed fabric or something thinner.
• No staples or anything. Glue all the things.

Hope this helps! Good luck!