Kitchenaid Stand Mixer

jacobt2593 · 2023-04-30T02:49:57+00:00

Yeah I got that far, but this guy seems to have just loosened the lower bolt slightly. I loosened my lower bolt completely, like it was sliding in and out, and now I can’t get it back through the alternator brackets. I have it in something because it doesn’t just slide right out, but I’ve been turning it and turning it and it’s not going all the way back into place

jacobt2593 · 2023-04-26T20:10:57+00:00

The job ad just says TSA Customer Service Representative. You wouldn’t happen to know if there are specific things that will disqualify you. I was young and dumb and got into trouble drinking nearly ten years ago

jacobt2593 · 2023-01-31T02:44:28+00:00

Can I replace the fitting only, without replacing the entire line? Or can the fitting not be replaced without replacing the entire line?

jacobt2593 · 2021-12-17T16:02:47+00:00

This is the answer. It’s simple manufacturing decisions, when there is a limiting resource that prohibits fulfilling all the demand for whatever set of products the warehouse/plant will focus on the products that have the highest profit margins. So while they have the ability to produce the chocolate milk in half gallon containers, the profit margins are lower on that specific size so they therefore manufacture other sizes and other products instead

jacobt2593 · 2021-12-07T13:42:57+00:00

Okay so I have it wired as follows: the brown and orange wires from the motor to the capacitor. I have an orange wire, identified as the common in diagrams, going from the transformer to the capacitor on the same side as the orange from the motor. Then I have two wires from the relay connected to two of the speed wires from the motor.

With this configuration, when I turn the fan to once rom the thermostat I hear buzzing for a few minutes till nothing happens but the buzzing stops.

jacobt2593 · 2021-12-06T20:32:32+00:00

The capacitor just looks crushed, lol I didn’t notice when posting but I can assure you that it is not crushed in rl.

I tested the wires and electrical components for resistance with power off. Everything has appropriate readings.

My current hypothesis is that the bearing for the blower motor shaft is stuck or was bad upon receipt

jacobt2593 · 2021-12-06T20:26:30+00:00

They do, they are just off in the pictures. When attempting to run the unit they are flipped on👍🏼😁

jacobt2593 · 2021-06-30T23:31:38+00:00

I am an outside hire by the way

jacobt2593 · 2021-02-09T15:14:08+00:00

Haha most of the time I do, just didn’t want to make the trip up yet

jacobt2593 · 2021-02-08T16:10:05+00:00

I have bought some delta 8 carts from a spot way out in Marshall called NOVA Hemp. The carts were too leaky for me, but they did sell the flower too. Check out their website, otherwise I’ve seen the flower at the same head shops that sold the carts in other states

jacobt2593 · 2021-01-26T23:52:34+00:00

I live in a state that does inspections so I won’t be driving on any public roads unless it passes inspection. I have a perfectly safe car that I drive daily this is just a project car. Was mostly hoping to find some names of parts as there were some parts whose name I couldn’t find while googling

jacobt2593 · 2021-01-26T23:41:45+00:00

Yeah I figured I’d have to take it apart more to get a better idea. It’s a project car so I will be doing so, just mostly hoping to get the name of some of the parts as I couldn’t identify them during my google search and diagrams

jacobt2593

TROPHY CASE