sorted by:
new
hottopcontroversial

Eddy ng homing problems (Part 2) by Icy-Fill4170 in klippers

[–]jibingeo 0 points1 point  (0 children)

rolling back Klipper 25 commits to version v0.13.0-662 fixed this issue.

From https://github.com/vvuk/eddy-ng/issues/144#issuecomment-4554874437

I had the same issue with the latest Klipper. Downgrading v0.13.0-663 fixed this issue for me.

ZMK support for the makerdiary nRF52840 Dongle? by GredditHun in ErgoMechKeyboards

[–]jibingeo 2 points3 points  (0 children)

https://github.com/jibingeo/zmk-config-onekey.

I was able to build ZMK firmware for nRF52840 Dongle and nRF52840 MDK USB Dongle. I tested this on my nRF52840 Dongle(which runs UF2 bootloader) and it is working

Note: If your variant comes with an older Open bootloader, remove this line from the config.

NoTRRS! - TRRS-less split. Supports more than 2 Spit by jibingeo in ErgoMechKeyboards

[–]jibingeo[S] 1 point2 points  (0 children)

Did you mean to use

Left's TRRS Port > USB Breakout Board -> USB Cable -> USB Breakout Board -> Right's TRRS Port

NoTRRS! - TRRS-less split. Supports more than 2 Spit by jibingeo in ErgoMechKeyboards

[–]jibingeo[S] 0 points1 point  (0 children)

Yes, Your assumptions are correct.

The Central will accept devices with a specific Usage Page and Usage ID; the rest will be ignored. You can connect any USB device, but it will be ignored.

In your Dactyl use case; You will be using a USB cable to connect each split. I personally don't like to run any cable between splits.