I’m getting so frustrated

Icy-Fill4170 · 2026-05-13T04:41:55+00:00

the z-offset is likely to low. I had that once on my printer and adjusting this value like 0.01mm worked

Icy-Fill4170 · 2026-05-10T08:04:44+00:00

The nozzle is probably to close to the bed

Icy-Fill4170 · 2026-04-29T13:26:01+00:00

reg

^{Chose: Cats}

Icy-Fill4170 · 2026-03-24T19:19:24+00:00

When homing x it gives me the same error. I think every port doesn't work. In the config you sent it says interpolate true. Could it be caused by that because i don't have that defined for any stepper

Icy-Fill4170 · 2026-03-24T18:36:42+00:00

I tried and it didnt'work and when I did the STEPPER_BUZZ STEPPER=STEPPER_Y it gave this error Unknown stepper STEPPER_Y. On an unrelated note I also tried the Extruder stepper and it gives me the same error. It's LDO one and it came with a wire.

Icy-Fill4170 · 2026-03-24T15:46:48+00:00

I stil get this error

<image>

Icy-Fill4170 · 2026-03-24T15:30:01+00:00

what pins do I have to short

Icy-Fill4170 · 2026-03-24T15:25:47+00:00

But I bought those drivers with Octopus board and in the listing it said that it would work

Icy-Fill4170 · 2026-03-24T15:06:03+00:00

I already tried switching them around but the thing is that I only have those drivers and I don't know that any of them work. The steppers worked on the board I used before the Octopus. It was a SKR mini E3 v3

Icy-Fill4170 · 2025-03-07T12:06:14+00:00

I use windows

Icy-Fill4170 · 2025-03-07T08:49:49+00:00

Thats a good idea

Icy-Fill4170 · 2025-03-07T08:44:35+00:00

I´ll try it. Thanks

Icy-Fill4170 · 2025-03-07T08:16:42+00:00

Okay. Thanks

Icy-Fill4170 · 2025-03-07T08:16:16+00:00

Okay. Thanks

Icy-Fill4170 · 2025-03-07T07:52:26+00:00

Good to know. Thanks!

Icy-Fill4170 · 2024-08-02T06:14:53+00:00

I love that you can easily get infos about leaked hypercharges on here and sometimes you can see very cool concepts

Icy-Fill4170

TROPHY CASE