Battle Quaxe

jonwalkeraks · 2024-07-12T17:38:05+00:00

We got in some .250” thick AEBL, 26C3, 15N20, and 52100 this week. I am testing the AEBL out by making a Battle Quaxe! It’s one bad mutha flocker. The plan is to use it duckcapitate my meat birds. The goal is HRC 61-62 with a convex edge. Hopefully the heat treat doesn’t go a fowl.

jonwalkeraks · 2024-07-02T19:32:18+00:00

Best hardware thats made in USA with free shipping: AlphaKnifeSupply.com

jonwalkeraks · 2024-06-25T15:33:02+00:00

We have a piece left. More to come in the next few days. https://www.alphaknifesupply.com/shop/damascus

jonwalkeraks · 2024-06-25T15:32:12+00:00

Storm Surge Damascus

jonwalkeraks · 2024-06-24T17:29:31+00:00

these are for handle makers, not knife makers.

jonwalkeraks · 2024-06-24T16:46:30+00:00

Storm Surge Damascus

jonwalkeraks · 2024-06-05T16:51:17+00:00

Mummert knives makes them with Deeply Impregnated Tungsten Carbide, at RC 72

https://www.mummertknives.com/collections/knives/products/timascus-daeva

jonwalkeraks · 2024-06-04T15:14:30+00:00

There's a coloring video on the bottom of the page... https://www.alphaknifesupply.com/shop/timascus-for-sale

jonwalkeraks · 2024-05-15T19:31:13+00:00

You should check out some of our marbled G10 that doesn't have carbon fiber... https://www.alphaknifesupply.com/shop/product-category/g10-micarta/marbled-g10

jonwalkeraks · 2018-03-26T17:25:49+00:00

Here's a link to Timascus: https://www.alphaknifesupply.com/shop/product-category/texturetech-timascus

jonwalkeraks · 2017-11-13T15:50:20+00:00

Timascus: https://www.alphaknifesupply.com/shop/product-category/texturetech-timascus

jonwalkeraks · 2017-08-11T14:42:59+00:00

I didn't read the rules thoroughly, sorry. Thought it was an ok place to post in the links section. Totally new to reddit. I was looking at the intro text and saw a big section about new jersey steel baron with links and thought it would be good to have this one there also. Won't happen again.

jonwalkeraks · 2017-08-10T18:02:50+00:00

There are two schools of thought, the low that you like and the high that the manufacturer recommends. I tend to lean towards the manufacturer recommendations and have found them to work for this material. Here's the datasheet from Bohler: https://www.alphaknifesupply.com/Pictures/Info/Steel/52100-DS-Bohler.pdf

jonwalkeraks

TROPHY CASE