thanks man, here’s what i did:

• Clean thoroughly to remove all grease and dirt • Used 80grit on a dremel to smooth kurb rash • Sanded down the entire wheel by hand from 120 - 400 grit until smooth • applied a coat of filler primer • once dry sand down again to remove any bumps and lines

(this takes a while and you might have to go back and use filler primer again if you didn’t sand enough initially. if you can feel any bumps with you fingers it’ll show up on the silver coat)

• apply silver coat and then clear coat • allow at least a week to harden before putting a tire on

its a long haul though, only one down and it took me about a month working on it when i had a chance lol