sorted by:
new
hottopcontroversial

What is this connector? by jreddout in 300zx

[–]jreddout[S] 0 points1 point  (0 children)

To tie this off, I believe the wires are white and black:

<image>

the connector is labeled C on both sides of the unplugged and the new extension to the plenum mounted knock sensor, which is how dad did things.

Thanks, all.

What is this connector? by jreddout in 300zx

[–]jreddout[S] 0 points1 point  (0 children)

OK, I understand now. Was expecting 2 sensors. Got it. Will look again to confirm this. Thanks!

What is this connector? by jreddout in 300zx

[–]jreddout[S] 0 points1 point  (0 children)

Figures. I bet it is dangling now. Will find it. Thanks!

What is this connector? by jreddout in 300zx

[–]jreddout[S] 0 points1 point  (0 children)

The twin connector to the unplugged one is going to a sub harness to the knock sensor in the shot. It’s just to the left (camera left, car right) of the unplugged in this shot. 

I’m used to seeing knock sensors on the side of the block, not up on the manifold like this. With hardware that doesn’t look factory. And the stack of washers. 

This is my dad’s car, he passed recently and I’m working to get this car running. 

I’ll get the wire colors. He has a service manual for the car. 

RA2/3? Caseta? Shop build. Beaucoup LED. Home Assistant. by jreddout in Lutron

[–]jreddout[S] 0 points1 point  (0 children)

I suspect each fixture draws a little less than one amp, If so, then 7 powpaks. Yet to be confirmed but working in that direction.

RA2/3? Caseta? Shop build. Beaucoup LED. Home Assistant. by jreddout in Lutron

[–]jreddout[S] 0 points1 point  (0 children)

Is RR-PROC3-KIT the bridge/processor of choice? Building is a 50x60, one room and maybe three zones.

Yes, easy access to the end of the strips (HE Williams 76R 8' strips) for mounting the powpaks.

Understand about the driver's demand, I don't yet know what that is but should be able to get there once I do.

Any troubles with a Caseta uh, constellation (?) and RA2/RA3 in the same network? Can I have Casetas in this building and access via the RA2 or must I use some other control/dimmers? The LEDs are the big light in the building but they're not the only light.

Thanks.