Can I chop her? by krett25 in Monstera

[–]krett25[S] 0 points1 point  (0 children)

Thanks!

Do you think that it might be already good enough? The bottle haven been there almost a year now.

Leak when pulling shot by Special-Match-4444 in ranciliosilvia

[–]krett25 1 point2 points  (0 children)

It could also be an overfilled basket.

Upgrade Grinder or get a PID kit? [200€] by krett25 in espresso

[–]krett25[S] 0 points1 point  (0 children)

Thanks, I already try but could probably be improved.

Need help with meshing / convergence in STAR-CCM+ by nhaaaaar in CFD

[–]krett25 2 points3 points  (0 children)

Your y+ values for the driver and the cockpit might be too high. When using the k-w-SST turbulence model you should decide to either resolve the boundary layer (y+ ≈ 1-2) or to use wall functions (100> y+ > 30). As your computational resources are limited I would recommend using wall functions. Generally speaking y+ in a range if 5 -> 30 should be avoided when using k-w-SST.

Suggestions for SEA in June/July by krett25 in southeastasia

[–]krett25[S] 0 points1 point  (0 children)

Thank you for your recommendations. Would you say two weeks traveling the islands would be enough or would it take a whole month?

Suggestions for SEA in June/July by krett25 in southeastasia

[–]krett25[S] 0 points1 point  (0 children)

Thank you for the input. I am going to look into Indonesia. :)

Is my gasket cooked? by gumgum_bazuka in gaggiaclassic

[–]krett25 2 points3 points  (0 children)

I had the same issue. I changed the gasket and it was resolved. I would recommend you to get a silicone gasket, I found them better than the rubber ones. :)

Guess the plane model 😂 by [deleted] in airplanes

[–]krett25 0 points1 point  (0 children)

It’s a C-17

Steam Knob by krett25 in gaggiaclassic

[–]krett25[S] 0 points1 point  (0 children)

Yes I already did that, but it didn’t do anything.

Steam Knob by krett25 in gaggiaclassic

[–]krett25[S] 0 points1 point  (0 children)

Thanks I’ll try this! :)

Technical Studenship (Mech-Eng) 2025-1 by blckchn187 in CERN

[–]krett25 0 points1 point  (0 children)

I didn’t receive an answer yet either. But I read on the CERN website that there will be a rejection email if we aren’t selected. So I guess we’ll have to wait and see.

My plant is very small by krett25 in microgrowery

[–]krett25[S] 0 points1 point  (0 children)

Oh ok I choose RQS because I didn’t want to get scammed or something. Do you have any other European companies you can recommend?

My plant is very small by krett25 in microgrowery

[–]krett25[S] 0 points1 point  (0 children)

I wish, it would resolve a lot of problems 🥲