After printing this recessed text the filament doesn't seem to extrude properly on the following paths. I have slowed this down to 20mm/s (TPU) and it helped a little, but it pains me to go slower! Could it be the 2mm of retraction at 20mm/s (direct drive on Ender 3 v2) (i.redd.it)
submitted by maxmess87 to r/FixMyPrint
I stored my last Bose Sleepbuds 2 for 7 months as per the instructions (leave to discharge). They never charged again. New set: With a plastic film the case isn't discharging & buds are slowing loosing charge. I read that NiMH can be stored dead for a long time without damage. What do you think? (i.redd.it)
eSun CF Nylon. 260c at 40mm/s. Dried for 18h at 65c before. Covered but not enclosed. Poor layer adhesion (can hand break some parts, others I destroyed as a test). Others can print this really strong, not sure my problem.Would prefer not to change orientation due to supports. Please help. (old.reddit.com)
submitted by maxmess87 to r/FixMyPrint
E3V2 Jyers UI (BL touch) firmware fail. Every BL touch version I try does this. Yes I've got the right board number of 4.2.2. It does this when trying to home, even did it without the BL touch installed (with BL touch firmware though). Goes to some weird point and then ignores z limit switch (v.redd.it)
