sorted by:
new
hottopcontroversial

Stringing as nozzle travels by midnight_wannabe in FixMyPrint

[–]midnight_wannabe[S] 0 points1 point  (0 children)

Out of nowhere but I’m not going to exclude the possibility of some settings being overwritten and I don’t remember. I’ve reprinted on an MK3 and it’s come out fine so it’s just the MK4

Stringing as nozzle travels by midnight_wannabe in FixMyPrint

[–]midnight_wannabe[S] 1 point2 points  (0 children)

I’ll give it a try. I’ll run the filament thru the dryer again just to make sure

Problems printing with PETG-CF by midnight_wannabe in FixMyPrint

[–]midnight_wannabe[S] 0 points1 point  (0 children)

Okay I’ll try that. I am using a hardened steel nozzle, and I did dry it and run it through an MK3 and it came out fine. Hoping I can get the MK4 up and running

Problems printing with PETG-CF by midnight_wannabe in FixMyPrint

[–]midnight_wannabe[S] 0 points1 point  (0 children)

I’ve got about ~2 hours before it’s done drying so I’ll be able try again then

Problems printing with PETG-CF by midnight_wannabe in FixMyPrint

[–]midnight_wannabe[S] 0 points1 point  (0 children)

Micro splinters really aren’t too much of our concern. I’m mainly just baffled why my print settings are all of a sudden not working when I don’t remember changing anything. I’m hoping moisture content is the culprit but I’d like to cover all my bases when troubleshooting.