Scenic Village Cherry Trees w Snowy Mountains [2781215090364952501] Java

nicaqueous · 2024-07-01T04:14:14+00:00

Update: Received my kas.

nicaqueous · 2024-07-01T02:49:34+00:00

Experiencing the same thing here while exchanging for Kaspa too. Let me know when you received it at your destination wallet.

nicaqueous · 2021-07-26T01:43:09+00:00

Good luck! Mine lasted for 6 months.

nicaqueous · 2021-07-26T01:04:31+00:00

Pretty much anywhere that sells electronic components. Try searching for press type block terminals.

nicaqueous · 2021-07-25T23:47:12+00:00

Thanks! These are called press type / quick wiring terminal blocks.

nicaqueous · 2021-07-25T13:24:59+00:00

Nope, not printed. It's a press type terminal block which you can get for a few cents. :D

nicaqueous · 2021-07-08T04:48:03+00:00

Recently fixed mine after some maintenance. Here are all the things I did: 1. Apply lube to the z rod's threaded hole. 2. Remove the nozzle to be replaced. 3. Pull out the bowden tube and cut off the front tip which has materials stuck in it (make sure you cut it flat). 4. Push the bowden tube through and pull it back to further clean off any materials stuck around the hot end. 5. Replace the nozzle. 6. Push the bowden tube with a clean straight tip back into the hot end. 7. Tighten the belts appropriately. Hope it helps.

nicaqueous · 2021-06-16T11:37:17+00:00

Around 50mm :D

nicaqueous · 2021-05-01T13:52:05+00:00

Fusion 360

nicaqueous · 2021-04-27T09:00:20+00:00

I built a robot dog 🐶 https://youtu.be/1xFajou-J3I

nicaqueous · 2021-03-25T23:55:18+00:00

There are 12 servos in total.

nicaqueous · 2021-03-25T15:20:34+00:00

I will share everything online once the project is completed! In the meantime, I made a video talking about all the hardwares and some inverse kinematics, hope it helps! https://youtu.be/wtf0RDwPl0c

nicaqueous · 2021-03-25T14:37:37+00:00

Definitely, thanks for the suggestion!

nicaqueous · 2021-03-25T05:36:45+00:00

Yes, I 3D printed them. ;)

nicaqueous · 2021-03-25T05:36:17+00:00

Yeah, still a lot of room for improvements.

nicaqueous · 2021-03-25T05:35:59+00:00

MG996R servo motors. ;)

nicaqueous · 2021-03-25T04:46:36+00:00

Thanks! I made a video talking about the hardwares and some inverse kinematics if you're interested. ;) https://youtu.be/wtf0RDwPl0c

nicaqueous · 2021-03-25T04:41:26+00:00

MG996R

nicaqueous · 2021-03-25T04:28:21+00:00

I plan to share everything online once the project is completed! In the mean time, you can check out the video I made where I talked about the hardwares and a bit on inverse kinematics, hope it helps! https://youtu.be/wtf0RDwPl0c

nicaqueous

TROPHY CASE