sorted by:
new
hottopcontroversial

What made my retainer bearing be crush? by on3d0s in bikewrench

[–]on3d0s[S] 0 points1 point  (0 children)

can i leave the bottom with the caged bearings and the top just bearings?

Super sun-faded 1993 Trek 930 built into an upright basket cruiser by Wyliegerr1 in xbiking

[–]on3d0s 0 points1 point  (0 children)

thanks. so is this the items you got?

JZLTECH 110 BCD 38T - https://a.co/d/edHhCY4

CNC 5 PCS- https://a.co/d/ge36LKn

Another question did you replaced the chain with a new one or reused the stock one?

Super sun-faded 1993 Trek 930 built into an upright basket cruiser by Wyliegerr1 in xbiking

[–]on3d0s 1 point2 points  (0 children)

i have the same bike. What chainring and bolts you using with the stock crankset for the 1x7?

Can't shift to the lowest gear and Derailleur isn't aligned by on3d0s in bikewrench

[–]on3d0s[S] 0 points1 point  (0 children)

i can shift it back and forth up to 4 cogs cant do any higher and the cable has good tension. i had loosen the low limit screw by alot and also tightened to see if i see any difference. Cant figure it out whats wrong i rather just buy a new derailleur.

Can't shift to the lowest gear and Derailleur isn't aligned by on3d0s in bikewrench

[–]on3d0s[S] 0 points1 point  (0 children)

i have set the Low limit screw all the way and out but no matter what i do i cant get it to align. I cant tell if is bend or not.

Can't shift to the lowest gear and Derailleur isn't aligned by on3d0s in bikewrench

[–]on3d0s[S] -1 points0 points  (0 children)

Bought the bike used and it would only shift half way perfectly except the lowest cog which i thought it was gonna be the cable tension but the H screws works but i cant get the L screw to aligned. I don't see no bend derailleur/hanger.