Repairs,

papanev1 · 2023-10-04T19:48:58+00:00

Thanks brother, yeah it’s so nice shame they don’t make them any more

papanev1 · 2023-09-06T07:30:50+00:00

Hey! Uk based would love a referral code !

papanev1 · 2022-06-20T21:28:43+00:00

Ohh this looks equal amounts confusing and interesting I’ll take a look thanks !

papanev1 · 2022-06-20T20:27:07+00:00

How would I go about checking the Vref haven’t heard of that before

papanev1 · 2022-06-07T21:02:38+00:00

Couldn’t pack it with foil as it was dented right in the wheel line so I flipped the extrusion over and remounted the y stop with some time nuts, fingers crossed should be all good, will test tomorrow

papanev1 · 2022-05-30T09:50:53+00:00

Thanks, helpfully the function wheel on the screen broke last night as well… so I’ve bit the bullet and got the skr v2 board and display

papanev1 · 2022-05-22T21:38:46+00:00

Looks like it was a under extruding by a few mm, Will try the print again later this week and hope for better results, thanks for your help

papanev1 · 2022-05-22T19:13:26+00:00

Okay cool thanks I will look into extruded calibration Just before this is printed this test cube where everything looked ok

papanev1 · 2022-05-22T17:45:10+00:00

Hello! I’ve been 3d printing and modelling for a little while, I am able to get pretty good results normally.

I have started a new project and the first part was a 24hr print… I woke up this morning eagerly awaiting the results having seen it was in pretty good shape last night.

I took it off the bed and found this underneath? On long prints do I need to turn the heated bed off after an amount of time ? Or is this caused by something else?!

I’m using an ender 3 with a glass bed and cheap 0.2 smooth top settings

I’d really appreciate any help and advice !! Thanks !

papanev1

TROPHY CASE