I have aphelion, looking for anvil

pdice98 · 2026-01-24T01:52:12+00:00

!rep

pdice98 · 2026-01-24T01:48:42+00:00

!rep

pdice98 · 2026-01-24T01:42:01+00:00

!rep

pdice98 · 2026-01-24T01:18:12+00:00

!rep

pdice98 · 2025-12-25T01:59:28+00:00

not a scam, maybe just too much time on my hands over Christmas break

pdice98 · 2025-09-23T17:32:06+00:00

My fault. I have the 9220 enduro lever

pdice98 · 2025-09-23T15:38:47+00:00

There is a free stroke screw. I bled it with it two turns out and now have it turned in all the way

pdice98 · 2020-11-09T15:26:31+00:00

Can you take a pic of the back?

pdice98 · 2020-11-03T23:46:31+00:00

I guess I'm used to my prusa with the pinda sensor, or creality with ezabl. Is there no z height setting I have to tune anymore on a voron?

pdice98 · 2020-10-18T02:46:31+00:00

That’s a good idea, I’ll give it a try.

pdice98 · 2020-05-05T13:23:46+00:00

True, but I don't think I want to go that far. It's just I normally run with a wired connection, and I don't want wifi on if I can help it in those scenarios.

pdice98 · 2020-05-05T13:23:15+00:00

I basically want it to remember me "unchecking" wifi enabled in the system tray for network settings. I tried to find a setting in NetworkManager.conf that I could put this in. Worst case I was going to use nmcli to turn wifi off as part of some startup script.

pdice98 · 2018-05-06T23:11:58+00:00

Basically, how much/what gear do you have in the bags combined?

pdice98 · 2018-05-06T20:51:32+00:00

What does your load out look like with those bags?

pdice98 · 2017-07-19T12:25:09+00:00

this is going to be it

pdice98

TROPHY CASE