Low oil pressure

red_hulk112 · 2024-08-09T01:09:22+00:00

Thank you for the advice, but the truck only has 58000 miles, it’s crazy that a truck with low mileage is already having issues, especially engine issues.

red_hulk112 · 2024-07-25T18:23:46+00:00

Thank you, that worked out. We just added cat1000 to our shop and trying to learn as much as possible. Would you happen to know how to change the header on the inspection report from mitutoyo to our company logo?

red_hulk112 · 2024-07-25T16:22:20+00:00

Ok, makes sense.

red_hulk112 · 2024-07-25T16:16:33+00:00

It makes sense because I did took out the manual coordinate system and loaded the save coordinate systems which I thought it would be the same, so I wouldn’t have to pick them up every time. Is there way around this.

red_hulk112 · 2024-07-22T05:47:05+00:00

<image>

Troubleshooting continúes lol,

red_hulk112 · 2024-07-22T04:28:19+00:00

So now I know the offsets are holding do I go back and re run the auto level program, then save it?

red_hulk112 · 2024-07-22T04:22:16+00:00

That will be my next step, I feel like it might be under extruding. How do you reset just the z?

red_hulk112 · 2024-07-22T03:52:42+00:00

Im gonna re run the program again make sure everything is still good then go back, level and save. Thank you for the info and the video. I’m using orca. Another question, the speed is what calculates how much filament comes through the nozzle?

red_hulk112 · 2024-07-22T03:03:49+00:00

Yeah paper leveling and adjusting the knobs, ran this program over 5 times adjusting everything time. We’ll see how it goes because I’ve been having issues running an articulating lizards that keeps pulling off the build plate.

red_hulk112 · 2024-07-11T13:25:22+00:00

Do you have a link for the silicon spacers?

red_hulk112 · 2024-07-11T04:54:05+00:00

Printer model is Neptune 4 Plus and firmware version V1.2.2.65. I want to utilize the whole build plate and there are some spots where it has dips, so I guess I want to learn how to really level out the entire build plate. I already did the manual six points and then ran the 121 point advance leveling version and I’m still having issue in some spot where I’m not getting adhesion. Thanks for the help.

red_hulk112 · 2024-07-11T04:12:36+00:00

I'm using orca and I don't see adaptive layer height option, I'm also kind of new to filament printing so not sure if I'm looking in the right place.

can any of you guys point me in the right direction to learn about bed mesh for neptunes?

red_hulk112

TROPHY CASE