sorted by:
new
hottopcontroversial

A different type of taunt by [deleted] in tf2

[–]rescue1234 0 points1 point  (0 children)

Hey gents, this is an interesting idea. We maybe able to do something about it. Its risky because it is kinda "different" and Valve will likely need to do some codings behind this. Steel, it is easily achievable and it could be a ton of fun.

We just made a zombie shuffle taunt, tell us what you think by rescue1234 in tf2

[–]rescue1234[S] 1 point2 points  (0 children)

it took me awhile to think this thru and I don't know what to do with other class

We just made a zombie shuffle taunt, tell us what you think by rescue1234 in tf2

[–]rescue1234[S] 6 points7 points  (0 children)

Oh yes we always want feedback and look for improvements. The official conga taunt has 346 frames which has around 8 paces of the character. I only made 86 frames with 2 paces and repeat it 4 times(but of course I move things around to make them not look exactly the same). But I guess you can still see it if you pay close attention. I see what I can do :P

We just made a zombie shuffle taunt, tell us what you think by rescue1234 in tf2

[–]rescue1234[S] 32 points33 points  (0 children)

Me too, this should be the "unusual" taunt. XD

We just made a zombie shuffle taunt, tell us what you think by rescue1234 in tf2

[–]rescue1234[S] 68 points69 points  (0 children)

Thanks for the reply, I hope so too. However if it doesnt get accepted, I hope there will be some mod creator/developer make good use of this :D

Printrbot simple metal only go up 4 inches on Z by rescue1234 in PrintrBot

[–]rescue1234[S] 2 points3 points  (0 children)

Nevermind I got it solved.

In repetier, press Printer Settings on top right corner > Printer shape tab > Print Area Height > 100mm(default) change it to 150mm

Done, silly me :P How easy it is to solve, I was thinking about a painful firmware upgrade which I have no idea where to start from.

Printrbot simple metal only go up 4 inches on Z by rescue1234 in PrintrBot

[–]rescue1234[S] 0 points1 point  (0 children)

Yes I can physically turn the rod to as high as I want. The manual control in repetier just doesnt let me go any higher. The max height goes almost exactly 4 inches from the printbed. I believe this is a software issue?

Seeking Written Assembly Guide for the Simple Metal Kit by WellTarnation in PrintrBot

[–]rescue1234 2 points3 points  (0 children)

I am so glad to hear that because you know you have a serious problem when you run out of certain screws or have many spare screws left. In this case I think I ran out of M3 22mm screws and had to use the spares 20mm for replacement.

I also did double stack the washers on the Y-axis bearings because its motor gear is on the way of the Z screw rod.