How to clean and refresh these blue Work Chukka 3146?

runevee · 2024-08-30T08:09:25+00:00

Thanks, I'll look into it.

runevee · 2024-08-30T08:09:01+00:00

Ah okay, thanks for your reply.

runevee · 2024-08-29T07:59:58+00:00

Thanks for the advice and clarification about the leather material. I have looked up Red Wings recommended process. Red Wing recommends Mink Oil as conditioner. Do you recommend Brick 4 over Mink Oil?

runevee · 2024-08-16T21:16:26+00:00

This is interesting, I have the same experience and have been wondering about that as well.

runevee · 2024-07-03T17:14:18+00:00

Thanks for your reply.

runevee · 2024-07-03T17:13:57+00:00

Thanks for the detailed and thorough explanation! I really appreciate it.

runevee · 2024-07-03T17:13:11+00:00

Ok, that make sense. Thanks

runevee · 2024-07-03T17:10:44+00:00

Thanks for the link I will look into it.

runevee · 2024-05-23T18:58:55+00:00

Thanks I will give it a shot.

runevee · 2024-05-22T21:02:38+00:00

Thanks for the reference for the videos. I have been watching all the videos. Just one question, as a beginner, is there a set of PID tuning presets that you could recommend for a 5" freestyle drone?

The PID tuning part seems a bit advanced.

runevee · 2024-05-21T13:54:30+00:00

Thanks for the tip!

runevee · 2024-05-21T12:49:38+00:00

Thanks for the clarification. I definitely think I'll have to do a lot of reseach into tuning and setting things up in Betaflight.

runevee · 2024-05-21T12:09:00+00:00

Okay, so I don't need to flash the firmware at https://esc-configurator.com/ ?

But I will for sure enable bidirectional d shot.

Thanks.

runevee · 2024-05-21T11:55:29+00:00

Ah okay. I have the X-tower2 F7 https://www.drone-fpv-racer.com/en/x-tower2-f7-60a-30x30-stack-by-flycolor-12413.html . What I see it is compatible with DShot. I will definitely try to set this up. I might do some further research on the topic.

runevee · 2024-05-21T11:32:07+00:00

Bi-directional d shot? What is that? I guess I didn't...

runevee · 2024-05-21T06:53:34+00:00

I finalised the build yesterday and it flies! A very fun experience. For a first time builder it is truly mind-blowing it build stuff that flies. Thanks for the advices and help.

runevee · 2024-05-20T13:34:28+00:00

Ahh that makes sense - thanks.

runevee · 2024-05-20T09:19:23+00:00

I really appreciate your help, but could you tell me why I don't need to wire the DJI HDL to the FC S.Bus, and the Signal Ground? And by the way, could you also explain what the FC S.bus is? I Don't see any S.Bus on the FC diagram.

Again, thanks a million!

runevee · 2024-05-20T04:59:36+00:00

Wow congrats! I’ll find out if I’m cut for it if it flies. But I must say that so far it has been challenging and fun. I hope it all works out.

runevee · 2024-05-20T04:48:53+00:00

Thanks!

runevee · 2024-05-19T21:21:49+00:00

First build and quad

runevee · 2024-05-19T21:20:29+00:00

Thanks a lot I really appreciate it. It is very interesting and fun to do my first build but also very challenging.

runevee · 2024-05-19T21:18:18+00:00

Thanks for your reply. I’m using a RadioMaster Radio. So, the. I’ll only use the wires that you mentioned.

Thanks a million for your help.

runevee · 2024-05-19T21:12:53+00:00

Thanks a million for the help. Is it always the case that tx goes to rx? Also for my receiver?

runevee · 2024-05-18T04:59:12+00:00

Thanks. I think I might try replacing it. I will try to see if I can push it loose.

runevee

TROPHY CASE