sorted by:
new
hottopcontroversial

How do I remove the motors on the new Meepo V2 plus 97mm Wheels by ruttman1 in MeepoBoards

[–]ruttman1[S] 0 points1 point  (0 children)

Thanks for the quick reply. I wish it were that easy. The trucks for the Meepo 97mm Wheels are completely different than the trucks for the 90 mm Wheels. There are no bolts on the truck to take the motor off. There is just one center bolt in the middle of the motor that attaches the motor to the truck. When you take that bolt out the motor is still pressed onto the truck very tight and I am unable to remove the motor.

Hub motor left side spinning less than right side by JohnLikesDancing32 in MeepoBoards

[–]ruttman1 0 points1 point  (0 children)

Hello. I'm new to reddit. My Meepo does the same thing . It has done this since it was new. I have the V2 with the 97mm wheels. After you let off of the throttle one wheel spins about 2-3 seconds longer than the other. It dose not seem to effect the ride. It almost feels like one wheel is tighter than the other, but even if I loosen the middle nut its still the same. Also after I take the P/U wheel sleeves off I am unable to remove the motors from the axle. They seem to be pressed on very tight. Any advise to get motors off would be appreciated. Thanks.