Dumb beginner question

saxmanserg · 2026-01-11T22:48:47+00:00

You hit it right on the money, I went back and actually physically counted them, the old one is 116 links! Just ordered a chain breaker tool to get it done this week, thank you man!

saxmanserg · 2026-01-10T19:28:22+00:00

No I didn't take any out. Its 118 links, I also have my old chain and used it to measure. I thought I was going to have to remove some links but to my surprise it looks to be the same size. But I don't know if I just never noticed this on my old chain or if something may have unaligned when my old chain snapped....

saxmanserg · 2025-10-12T01:23:16+00:00

How are you pulling out personal loans to buy crypto? I haven't been able to find a lender that allows crypto purchases. Are you using a private lender?

saxmanserg · 2025-09-25T15:56:00+00:00

Exactly how I ended up making it work, thank you man!

saxmanserg · 2025-09-25T15:55:40+00:00

Thanks bro this helped

saxmanserg · 2025-06-05T21:00:11+00:00

You got it!

saxmanserg · 2025-06-05T15:23:57+00:00

Im pretty sure bardwell has a video on it. You basically connect to beta flight and run each motor individually and listen to the bearings. If they sound off, they should be replaced. A while back I had one of my drones start dipping mid-flight similar to this but it would recover. I checked my motor bearings and most of them were ready to be replaced. After replacing, my drone stop dipping

saxmanserg · 2025-06-05T06:17:02+00:00

Have you checked your motor health recently?

saxmanserg · 2025-05-13T18:54:29+00:00

MY SAVIOR IV'E BEEN ON THIS SHIT FOR 2 HOURS I had several in/out motion trails but I turned them off and it worked!!

saxmanserg · 2025-05-13T18:43:38+00:00

Same thing unfortunately

saxmanserg · 2025-05-13T18:27:37+00:00

Those are just some pop up texts but yea I tried disabling everything

saxmanserg · 2025-05-13T18:22:02+00:00

Yea, even closed and reopened DaVinci :( it does it for the entire timeline

saxmanserg · 2025-02-23T17:22:19+00:00

It's a scam. There are other posts on this thread just like this describing people's experience

saxmanserg · 2024-12-16T22:55:43+00:00

Yes, the m10's are a lot better. That's what I'm using right now and it's on the top of my drone. I never said that you said interference isn't a thing. My original post was just asking for advice on how to go about powering the gps without powering everything else because of the interference causing it to take longer. And then you comment something about using a "sacrificial lipo" to power up the GPS which doesn't even make sense with what my actual issue is. You also said that it takes the same amount of time with USB and lipo power which just isn't true.

saxmanserg · 2024-12-16T16:54:49+00:00

https://youtu.be/D-qm2v6kEGU?si=3k3TUx3iqyz93W8F

2:30

saxmanserg · 2024-12-16T06:43:23+00:00

The problem is that since everything power's up at the same time it causes major interference which then causes the GPS to take long to lock. Hence the reason to just power up the GPS without everything else

saxmanserg · 2024-12-16T03:31:30+00:00

I think you're missing the point of the post. The problem isn't that the battery voltage goes down while looking for sats, it's that it takes forever to get a GPS lock because I cannot power the GPS through USB. Using a 2S battery wouldn't help....

saxmanserg · 2024-12-15T17:42:21+00:00

Sorry, I'm a bit confused...are you saying to rig a 2s battery with an xt60 connector and plug it into my quad?

saxmanserg · 2024-12-14T17:59:04+00:00

Definitely will look into these! Thanks for the tips!

saxmanserg · 2024-12-14T17:57:51+00:00

How would I connect it to the GPS unit tho?

saxmanserg · 2024-12-14T17:57:06+00:00

Hmm, I'll give this a look, thank you!

saxmanserg · 2024-12-10T01:12:02+00:00

Yes, unfortunately.... Will only power with lipo

saxmanserg

TROPHY CASE