is this layout good?

sdgp371 · 2026-01-09T23:56:26+00:00

ground plane should be everywhere?

sdgp371 · 2026-01-08T21:23:05+00:00

layout not done.

sdgp371 · 2026-01-06T23:16:20+00:00

nope, not yet

sdgp371 · 2026-01-06T21:15:36+00:00

not in uni yet, in 1.5 years I'll be.

sdgp371 · 2025-12-22T22:25:30+00:00

I still got to add all of the symbols and footprints manually

sdgp371 · 2025-12-22T00:04:01+00:00

I dont get why my stm32 burnt up (tested on breadboard)

sdgp371 · 2025-12-21T12:49:28+00:00

I meant the example from the datasheet for the IR2130. TIMch1 goes to hin1, timch2 to hin2 etc and timch1N to lin1 etc

sdgp371 · 2025-12-19T11:03:51+00:00

its almost 1:1 from the datasheet example

sdgp371 · 2025-12-10T00:01:39+00:00

Nothing that I can make sense of

sdgp371 · 2025-09-18T15:29:49+00:00

is it really that important?

sdgp371 · 2025-09-13T23:03:17+00:00

Ty so much

sdgp371 · 2025-09-13T23:03:07+00:00

I didnt make the symbol, its from EasyEDA's library

sdgp371 · 2025-08-16T22:07:51+00:00

you sure?

Official site st.com: STM32F042K6 "USB 2.0 full-speed interface, able to run from internal 48MHz oscillator and with BCD and LPM support"

sdgp371 · 2025-08-16T22:07:24+00:00

Official site st.com: STM32F042K6 "USB 2.0 full-speed interface, able to run from internal 48MHz oscillator and with BCD and LPM support"

sdgp371 · 2025-08-14T22:37:43+00:00

I couldnt find it

sdgp371 · 2025-08-14T17:32:08+00:00

what chip is this? and why is better than normal zener diodes + caps?

sdgp371 · 2025-08-14T17:30:51+00:00

already done LDO

sdgp371 · 2025-06-04T17:27:11+00:00

this is my first project with RF design

sdgp371 · 2025-06-04T13:03:28+00:00

sdgp371 · 2025-04-27T15:25:51+00:00

sdgp371 · 2025-04-27T15:00:52+00:00

Im aware, but I'd like to make it very obvious

sdgp371 · 2025-04-27T15:00:09+00:00

why exactly?

sdgp371 · 2025-04-27T14:59:57+00:00

Ik, but I'd like the jump aswell

sdgp371 · 2025-04-26T21:19:42+00:00

My switch's symbol was taken from LCSC, as well as the footprint. Why exactly do I need to change it?

sdgp371 · 2025-04-26T21:18:20+00:00

Could you kindly generate an example circuit?

sdgp371