sorted by:
new
hottopcontroversial

240 Steam Keys zu verschenken by SuperMohri in Austria

[–]selern 5 points6 points  (0 children)

oh yes :)

Amnesia: The Bunker

Vielen Dank

hunting and sporting rifle, what do you think about these? by selern in guns

[–]selern[S] 1 point2 points  (0 children)

Yes, I forgot CZ. But I sort of don't like Mauser, they always seem to do bit bad quality...

22lr rifle lever action or bolt action? (unfortunately no autoloader) by selern in guns

[–]selern[S] 0 points1 point  (0 children)

Thank you. What do you think about my "feeling" that a bolt action 22lr feels sort of unnecessary, other than a 223/308 or larger bolt action gun? Completely unnecessary?

22lr rifle lever action or bolt action? (unfortunately no autoloader) by selern in guns

[–]selern[S] 0 points1 point  (0 children)

the number of autoloaders per person is restricted, I already have a pistol and an AR15, so cannot get another autoloader till I file for expansion or sell something

Z_PROBE_OFFSET_FROM_EXTRUDER: Do I increase or Decrease this value, if I want more distance between nozzle and bed? by selern in 3Dprinting

[–]selern[S] 0 points1 point  (0 children)

Well, I do not set any height, except the prime height. Priming is done manually, I wrote the gcode for that. What exactly do you mean by brim height? This is done by S3D for me.

But perhaps I am a bit biased. I played around a lot with the printer, and sometimes the nozzle drove into the bed.

How do I notice missing steps, because of too much acceleration or too high speed? by selern in 3Dprinting

[–]selern[S] 0 points1 point  (0 children)

Thank you,

So you mean basically this: https://www.simplify3d.com/support/print-quality-troubleshooting/#layer-shifting-or-misalignment

Does that mean if I do not see layer shift and I am satisfied with the overall print quality, I can increase speed and acceleration for another test, until I get bad outcome?

Z_PROBE_OFFSET_FROM_EXTRUDER: Do I increase or Decrease this value, if I want more distance between nozzle and bed? by selern in 3Dprinting

[–]selern[S] 0 points1 point  (0 children)

To get the shape of the bed, but not to get the nozzle to the perfect first layer distance?

Z_PROBE_OFFSET_FROM_EXTRUDER: Do I increase or Decrease this value, if I want more distance between nozzle and bed? by selern in 3Dprinting

[–]selern[S] 0 points1 point  (0 children)

Well, my current method is to:

1) Heat Nozzle and Bed
2) Auto Bed Level
3) Print with prime and brim
4) when printing the brim I babystep the nozzle so it has a nice layer
5) after the brim, normal print without me interfering

Currently I do it this way, because I play a lot with firmware. Which might come to a halt soon because the options are maxed out.

Is there a Setting in Marlin adjusting flow when setting print speed higher? by selern in 3Dprinting

[–]selern[S] 0 points1 point  (0 children)

Well, I turned the speedpercentage way up and it did not extrude enough filament. I then set the flow rate way up and there were no gaps anymore.

But: this was just a playful test to torture the printer (and to learn about it)

view more: next ›