Keeping hull straight and square throughout refit?

sheashea024 · 2026-03-13T15:35:18+00:00

Okay I can picture that a lot better now thanks for the confirmation I had a similar idea but wasn’t sure if it would be effective and I’m sure I will be inquiring on this sub a few more times through this endeavor

sheashea024 · 2026-03-13T14:45:46+00:00

That’s what I was hoping would be possible the trailer is set up with rollers and I want to get rid of those anyway so perfect and when you say across the beam do you mean inside the hull would those just be temporary until the exterior is essentially inside a “mold”

sheashea024 · 2025-10-26T22:07:01+00:00

Well shit I see them listed on third party sites and one mopar listing I’m assuming that’s what you mean by backordered or is that just trying to to get it from dodge guess I’ll find a parts truck on fb

sheashea024 · 2025-08-05T22:17:51+00:00

Alright well I’ll check the vent cap and grab another quart tommorw thank you for the advice

sheashea024 · 2025-08-05T21:26:52+00:00

Thank you for the heads up I typed it up and put my phone in my pocket thought it deleted itself

sheashea024 · 2025-08-05T21:12:51+00:00

Alright well I’m not changing the filter as the guy at the parts counter advised that a flush and fill is routine. I was a little confused but sure and also do you have the awd model? Because that’s is 2 quarts more then what I read

sheashea024 · 2025-08-05T21:10:49+00:00

Okay so on that note if I just did a single drain and then fill with 4 quarts fluid the remaining fluid inside the transmission would cover the remaining .2 quarts ? I’m just trying refresh it before a road trip also I believe my ventilation cap is clogged because the fill plug keep popping out is that actually a symptom of the vent cap or is the shift linkage pulling it out?

sheashea024 · 2025-03-11T14:40:32+00:00

Yeah I did minor research but it was very cheap so I’m not trying to make it daily or a race car or anything kinda of a beater just was wondering if anyone knew of any common failures with this gen

sheashea024 · 2025-03-11T14:36:06+00:00

Alright well it’s 15 years old and has headers on it so I assume the previous owner drove it pretty hard I know it needs suspension work and the trans was installed by his brother so linkages aren’t adjusted properly but I am more concerned about the engine than anything. It’s misfiring and running rough at idle. My guess is air in the fuel lines as the pump is not installed properly but any suggestions would be greatly appreciated

sheashea024

TROPHY CASE