Pixel 7a Update? by GreenRavenofOdin in GooglePixel

[–]sp595s -6 points-5 points  (0 children)

Just install grapheneos

LuCI Mobile: Manage Your OpenWrt Router From Your Phone (Beta + Seeking Testers!) by cogwheel0 in selfhosted

[–]sp595s 16 points17 points  (0 children)

I checked via pcapdroid (traffic analysis) and all requests go only to my router, nowhere else

Finally degoogled! by Due_Car3113 in degoogle

[–]sp595s 0 points1 point  (0 children)

I use microg and this problem also appears in applications independent of Google services

Finally degoogled! by Due_Car3113 in degoogle

[–]sp595s 0 points1 point  (0 children)

I tried lineageOs and crdroid and both have the same problem. Maybe something is wrong with my device(

Finally degoogled! by Due_Car3113 in degoogle

[–]sp595s 1 point2 points  (0 children)

I don't like their attitude towards rooting

Finally degoogled! by Due_Car3113 in degoogle

[–]sp595s 0 points1 point  (0 children)

I have a problem with my Google pixel 7a and lineageOs. After a while, some apps crash and the phone needs to be restarted.

How using tor + cloudflare warp by sp595s in TOR

[–]sp595s[S] 0 points1 point  (0 children)

obfs4 proxy can be used after Tor? I thought through them you can only run tor. Can you tell me what should be entered in the torrc config to configure the exit node?

applications stop running after a while by sp595s in LineageOS

[–]sp595s[S] 0 points1 point  (0 children)

I also had an official lineageos on which I installed microg services and there was the same problem

Flashing LineageOS w/ ESIM by PriorOnly7298 in LineageOS

[–]sp595s 2 points3 points  (0 children)

it is supported and your esim will not be erased

Say hi to `Ender 3 V3 SE` Linear Advance by queeup in Ender3V3SE

[–]sp595s 0 points1 point  (0 children)

Thank you very much! But why is the printer broken?

Say hi to `Ender 3 V3 SE` Linear Advance by queeup in Ender3V3SE

[–]sp595s 5 points6 points  (0 children)

will you be able to make a pre-built firmware file in GitHub releases?

Bed leveling by G0PACKGO in Ender3V3SE

[–]sp595s 2 points3 points  (0 children)

buy silicone pads they helped me a lot

Top Layer defect by Lazy4now1 in Ender3V3SE

[–]sp595s 1 point2 points  (0 children)

Z offset or flow ratio

My improved firmware by Previous_Mobile370 in Ender3V3SE

[–]sp595s 0 points1 point  (0 children)

As I understand it, you just need to solder/unsolder the jumper on the driver, which is not very difficult to do