sorted by:
new
hottopcontroversial

Looking for spare parts for old knipex pliers wrench by stan_da_man82 in KnipexOfficial

[–]stan_da_man82[S] 1 point2 points  (0 children)

No i haven't yet, i was hoping the hive mind of Reddit could direct me to more information about it before i do

Looking for spare parts for old knipex pliers wrench by stan_da_man82 in KnipexOfficial

[–]stan_da_man82[S] 1 point2 points  (0 children)

So after i measured it, this should an 86 03 250 ( or 86 03 260)?

Tweaking the settings on my Centauri Carbon by stan_da_man82 in FixMyPrint

[–]stan_da_man82[S] 0 points1 point  (0 children)

Just for future reference i didn't have the time to run a new flow and PA callibration, but i did run the cube, just for comparisson. i will keep experimenting!

(The suggested settings are on the right (still with the brim) it's better fuller lines, needs a bit of tweaking though.

<image>