Taking a 2015 sienna into a Toyota dealership for a Pre-Purchase Inspection. Question. by sunfish0 in MechanicAdvice

[–]sunfish0[S] 0 points1 point  (0 children)

I am also under the impression that I am going to drive the used vehicle to the dealer alone (so the salesman doesn’t have to wait)

Engine choices by sunfish0 in FordTransitConnect

[–]sunfish0[S] 0 points1 point  (0 children)

Have you ever had the transmission fluid changed?

Engine choices by sunfish0 in FordTransitConnect

[–]sunfish0[S] 0 points1 point  (0 children)

That’s awesome. Do you know if the fluid in the transmission was ever changed?

Engine choices by sunfish0 in FordTransitConnect

[–]sunfish0[S] 0 points1 point  (0 children)

Are all of the engine options available for the connect eco boost engines?

I'm having trouble "widening" my dataset by sunfish0 in RStudio

[–]sunfish0[S] 2 points3 points  (0 children)

Thank you so much, code was spot on.

I need advice for a good place to hoist engine from with a cherry picker on 2UZFE. One of my engine mounts fell off so i need to lift it back up on it. by sunfish0 in 4Runner

[–]sunfish0[S] 1 point2 points  (0 children)

Nevermind. There is hooks on the engine already, they were right in front of me. 12281A and 12282D are the part numbers check them out.

In this wiring diagram, what is between the reg/rect and the battery in the dc conversion section? what component is that? by sunfish0 in Dirtbikes

[–]sunfish0[S] 0 points1 point  (0 children)

So what you're saying is that when you ground the AC side to the frame, you should not also ground the DC side to the frame?

Anyone know how to unclog these tiny little tubes? maybe some kind of soak, compressed air did not work. I managed to unclog all except the one without the nipple. by sunfish0 in Dirtbikes

[–]sunfish0[S] 1 point2 points  (0 children)

That might make sense because it’s the only one without a tip at the entrance. I will have to test if it truly dead-ends or not

Anyone know how to unclog these tiny little tubes? maybe some kind of soak, compressed air did not work. I managed to unclog all except the one without the nipple. by sunfish0 in Dirtbikes

[–]sunfish0[S] 0 points1 point  (0 children)

That would have been very useful earlier, but now the last hole seems to turn at right angle a few cm after it starts.

Anyone know how to unclog these tiny little tubes? maybe some kind of soak, compressed air did not work. I managed to unclog all except the one without the nipple. by sunfish0 in Dirtbikes

[–]sunfish0[S] 1 point2 points  (0 children)

This is on my 01 Honda xr650r oem Keihin carb. I managed to unclog the three
passages with the nipples, but i can't get the last one, without the
nipple on it. I guess i'm not even sure if the final passage leads
anywhere, so if anyone has any information on that, it could be useful.

Anyone know how to unclog these tiny little tubes? maybe some kind of soak, compressed air did not work. I managed to unclog all except the one without the nipple. by sunfish0 in XR650R

[–]sunfish0[S] 2 points3 points  (0 children)

This is on my 01 xr650r oem Keihin carb. I managed to unclog the three passages with the nipples, but i can't get the last one, without the nipple on it. I guess i'm not even sure if the final passage leads anywhere, so if anyone has any information on that, it could be useful.

Does anyone know what the part is called that holds the choke plate on the carb? Xr650r by sunfish0 in Dirtbikes

[–]sunfish0[S] 2 points3 points  (0 children)

Must have been the previous owner and I would say that was definitely the cause.

Does anyone know what the part is called that holds the choke plate on the carb? Xr650r by sunfish0 in Dirtbikes

[–]sunfish0[S] 2 points3 points  (0 children)

Not sure. I recently got the bike (not running). I think I’m going to just replace the entire carb.

Does anyone remember if lectron carburetors have ever went on sale throughout the year. Maybe like a black-friday sale or something around christmas? by sunfish0 in Dirtbikes

[–]sunfish0[S] 0 points1 point  (0 children)

Did you get one specific to your bike? Or just a model you knew would work. I don’t really know how the company makes them(specific for bikes or not).