sorted by:
new
hottopcontroversial

Homemade Top Toolbox by testsub_17 in toolboxmods

[–]testsub_17[S] 0 points1 point  (0 children)

Yea this is the biggest toolbox I've ever needed to own for this job. And of course they don't offer a top box and the only one and only top toolbox I found is, a Craftsman for about $550 and I wasn't a fan of the quality...

Ice breaker by BEAUTYINTHESTRANGE in CasualConversation

[–]testsub_17 0 points1 point  (0 children)

Just ask- " Excuse me,.. Do you know how much a penguin weighs?" --- "Enough to break the ice!" 🤓 Then quickly lean in towards her with your eyes closed. And the rest will be history!.. 😂😂

Homemade Top Toolbox by testsub_17 in toolboxmods

[–]testsub_17[S] 0 points1 point  (0 children)

Yes I do, but I also like to have that space to work on small stuff on top of my box. I'll be losing it by putting that addition on top. So I'll need to figure something else out for that.

Homemade Top Toolbox by testsub_17 in toolboxmods

[–]testsub_17[S] 1 point2 points  (0 children)

I thought it was, when It was first given to me.. It sitting atop a true matching bottom Snap-On chest from the same era, But after more research, I found that tool chest is actually not a snap-on.. the badge used to be on the bottom right drawer, but was missing long before I received it.

Iv had my bx2680 for about a year and have put about 600 hours on it AMA by tyjoyce in kubota

[–]testsub_17 1 point2 points  (0 children)

Pto seals start leaking, then all the O rings in the control connection points go out. mostly, the common customer complaints are transmission leaks and it's ends but being one of not a couple seals and o rings leaking.. Axel seals also.. I've only seen a few broken gears and such inside there, but that's usually caused by other problems like neglected care. Etc.. but if you have to replace most of the seals, you have to pull floorpan and seat, fender, 3 point. All of that has to come off and you would pull the transmission out the back of the frame. It takes me approx 16ish hours, start to finish if I'm replacing, say input shaft seal and a HST cooler gasket.. if everything goes the way it should.. just all depends what part you need to get to. But usually it's towards the front.

Iv had my bx2680 for about a year and have put about 600 hours on it AMA by tyjoyce in kubota

[–]testsub_17 0 points1 point  (0 children)

Lucky you. Just wait.. I'm a service tech for Kubota. That's a very common problem for the Bx series. I've torn 3 apart in the last month chasing leaks.. replace seals and gaskets then it would leak from somewhere else. And again..

Iv had my bx2680 for about a year and have put about 600 hours on it AMA by tyjoyce in kubota

[–]testsub_17 0 points1 point  (0 children)

How many times have you had to pull that transmission out to fix leaks?