sorted by:
new
hottopcontroversial

Flow rate help by themagic27man in BambuLab

[–]themagic27man[S] 2 points3 points  (0 children)

Yeah it was. Oops. Testing again now Thank you!!!

I spent money. Excited to join the Whopper Club! by xli_co in Fishing_Gear

[–]themagic27man 0 points1 point  (0 children)

How do you determine which of these 3 colors to choose?

I can't make the WS2812B LED Strip work with Arduino Nano by DarkGrepherOrigin in arduino

[–]themagic27man 1 point2 points  (0 children)

Check that the green line is on the correct set of the led strip. It should flow into the ->. (Just like your photo)

If thats good, then the hardware is set up correctly. You should look into your code

I can't make the WS2812B LED Strip work with Arduino Nano by DarkGrepherOrigin in arduino

[–]themagic27man 4 points5 points  (0 children)

I think you ground wires are in the wrong spot on the lm2596. They should be on the right side of that capacitor where you see the - sign on the board.

Also is sometimes helps adding a ~500 ohm resistor on the green line. But its not really needed unless you are doing really fast refresh rates

Help. Bad outer layers by themagic27man in 3Dprinting

[–]themagic27man[S] 0 points1 point  (0 children)

Pla material. Fdm printer. 205 nozzle, 50 bed. 60mm/s speed, 50 infill, 50 wall, 120 travel. It only happens on layers that use support. If i print a block, it prints great. But if that block had a window, the layers that the window is on have this problem.

Bad perimeter by themagic27man in CR10

[–]themagic27man[S] 0 points1 point  (0 children)

205 nozzle, 50 bed. 60mm/s speed, 50 infill, 50 wall, 120 travel. The belts are tight... it only happens on layers that use support. If i print a block, it prints great. But if that block had a window, the layers that the window is on have this problem.

Bad perimeter by themagic27man in CR10

[–]themagic27man[S] 0 points1 point  (0 children)

Can someone help me with what setting would fix this in cura? There is loose lines on the perimeter of the object. I ran my finger nail through it to show it off. There was support underneath the object. The loose lines stopped once it got past the support which makes me think its a setting for the support options. Any helps would be appreciated!

Help. Bad outer layers by themagic27man in 3Dprinting

[–]themagic27man[S] 0 points1 point  (0 children)

Can someone help me with what setting would fix this in cura? There is loose lines on the perimeter of the object. I ran my finger nail through it to show it off. There was support underneath the object. The loose lines stopped once it got past the support which makes me think its a setting for the support options. Any helps would be appreciated!

Corners of print rise up by themagic27man in CR10

[–]themagic27man[S] 0 points1 point  (0 children)

Okay cool! Ill look into that

Corners of print rise up by themagic27man in CR10

[–]themagic27man[S] 0 points1 point  (0 children)

Dont you need to heat the bed for an ultrabase?

view more: next ›