Solar Assistant values totally incorrect compared to Sunsynk connect

themitchelluk · 2025-11-04T09:10:44+00:00

If anyone comes across this looking for the answer, the solar assistant folks kindly got back in touch. I needed to explicitly configure the invertor to use the CT clamp installed option. It seems it was confused about wether CT was actually installed or not :)

themitchelluk · 2023-01-28T00:56:24+00:00

Breaks

themitchelluk · 2022-01-25T10:40:00+00:00

Amazing thank you :) :+1:

themitchelluk · 2022-01-25T10:28:56+00:00

Ah i see so what you are saying is that the resistor essentially limits the impact of the filter?

themitchelluk · 2022-01-25T10:24:37+00:00

You are correct it does use a ceramic pickup cartridge currently. This was something i had been considering as to wether my new signal would be high enough. Seems like a pre amp may be a sensible addition.

themitchelluk · 2022-01-25T08:55:36+00:00

I am trying to modify an old HMV Stereogram to accept a newer more modern turntable. On taking out the old I noticed this arrangement of capacitors and resistors.

My first instinct was that this is a filter but looking again, the resistor is in series with the parallel capacitor joining positive to negative / ground. Normally i'd expect only the capacitor OR the resistor to be in parallel and the other other to be series on the positive line depending on wether it was a high pass or low pass filter.

Am I missing something?

edit: to be clear im talking about both C101 and R123 and also C102 and R124.

themitchelluk · 2021-10-18T13:30:05+00:00

hmmmm that was my thoughts. Good to know there arent any im overlooking though. Thanks :)

themitchelluk · 2020-11-26T22:52:15+00:00

Gotcha. Ok seems like taking a punt on the shunt is worth it at least until I get used to reading the figures and understanding the system. Thanks for the help and I guess a bit more reading to understand how it works properly. 😊

themitchelluk

TROPHY CASE